User's Manual

WiFi Access Point

AP22 Series

Universal Mounting

Bracket

Ceiling Mounting

Bracket

Mounting Screws

WHAT’S INCLUDED:

AP22 Key Features:

+ Cloud-managed

+ 2x2:2 DBDC 802.11 ac Wave 2,

MU-MIMO

+ 802.1x authentication

+ Fast roaming

+ Dynamic radio resource

management

+ Data rate management

+ QoS enabled

+ Dedicated third radio for

spectrum analysis

+ Scheduled access control

+ 1 10/100/1000 Ethernet port

+ 1 USB port & IoT ready

+ 802.3af Power over Ethernet

(PoE) port

Model Numbers:

AP22-NA AP22-EU

THANK YOU FOR

CHOOSING CRADLEPOINT

Always Connected. Always

Protected.

View the full Quick Start Guide at:

cradlepoint.com/ap22

AP22-qsg-2pgr-092017-150mmx150mm.indd 1 10/10/17 4:56 PM

PAGE 1
THANK YOU FOR CHOOSING CRADLEPOINT Always Connected. Always Protected. AP22 Series AP22 Key Features: WiFi Access Point + Cloud-managed + 2x2:2 DBDC 802.11 ac Wave 2, MU-MIMO + 802.1x authentication + Fast roaming + Dynamic radio resource management + Data rate management + QoS enabled + Dedicated third radio for spectrum analysis + Scheduled access control + 1 10/100/1000 Ethernet port + 1 USB port & IoT ready + 802.
PAGE 2
Getting Started To make configuration changes to the access point: 1. Connect the access point to a Power-over-Ethernet (PoE) capable router. If no PoE is available, connect the access point to the router through either a PoE switch or a PoE injector. 2. The access point should be assigned an IP address by the router, indicated by a pulsing red LED. If after 60 seconds the access point has not been assigned an IP address, it will self-assign the address “192.168.0.1”, indicated by a solid red LED. 3.