User's Manual

Revision 1.0 23 Aug 2016 Document Part: 170709-000
SAFETY, REGULATORY, AND WARRANTY GUIDE
CRADLEPOINT IBR900LP6 MODEL: S5A643A
CRADLEPOINT IBR950LP6 MODEL: S5A648A
CRADLEPOINT IBR900NM MODEL: S5A644A
This important Safety, Regulatory, and Warranty Guide contains safety,
handling, disposal, regulatory, trademark, copyright, and software
licensing information.
Read all safety information below and operating instructions before
using the device to avoid injury.
FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
Reorient or relocate the receiving antenna.
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Increase the separation between the equipment and receiver.
Consult the dealer or an experienced radio/TV technician for help.
FCC CAUTION
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
this equipment.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
FCC STATEMENT
For product available in the USA/Canada market, only channel 1-11
can be operated. Selection of other channels is not possible.
Operation of the 5 GHz WiFi radios is restricted to indoor use only.
FCC RADIATION EXPOSURE STATEMENT
This equipment complies with FCC radiation exposure limits set forth
for an uncontrolled environment. This equipment should be installed
and operated with minimum distance of 40 cm between the radiator
and your body.
This device and its antennas(s) must not be co-located or operating in
conjunction with any other antenna or transmitter except in
accordance with FCC multi-transmitter product procedures.
To comply with FCC regulations limiting both maximum RF output
power and human exposure to RF radiation, the maximum cellular
antenna gain must not exceed 3.3 dBi. For Operation in Band 30, the
maximum cellular antenna gain must not exceed 1.0 dBi. Vehicle
installations with external antennas are not permitted to transmit on
Band 30 the device shall be configured for receive only on this Band
when installed in a vehicle.
To comply with FCC regulations limiting both maximum RF output
power and human exposure to RF radiation, the maximum WiFi
antenna gain must not exceed 5 dBi.
INDUSTRY CANADA STATEMENT
This device complies with Industry Canada license-exempt RSS
standards. Operation is subject to the following two conditions: (1)
this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause
undesired operation of the device.
For product available in the USA/Canada market, only channel 1-11
can be operated. Selection of other channels is not possible.
The device for the band 5150-5250 MHz is only for indoor usage to
reduce potential for harmful interference to co-channel mobile
satellite systems.
INDUSTRY CANADA RADIATION EXPOSURE STATEMENT
This equipment complies with IC radiation exposure limits set forth for
an uncontrolled environment. This equipment should be installed and
operated with minimum distance of 40 cm between the radiator and
your body.
This device and its antennas(s) must not be co-located or operating in
conjunction with any other antenna or transmitter except in
accordance with IC multi-transmitter product procedures.
This radio transmitter (IC: 6921A-S5A643A, 2417C-MC7455) has been
approved by Industry Canada to operate with the antenna types listed
below with the maximum permissible gain and required antenna
impedance for each antenna type indicated. Antenna types not
included in this list, having a gain greater than the maximum gain
indicated for that type, are strictly prohibited for use with this device.
This device has been designed to operate with cellular antennas
having a maximum gain of 3 dBi. Antennas having a higher gain are
strictly prohibited per regulations of Industry Canada. The required
antenna impedance is 50 ohms.
These devices have been designed to operate with WiFi antennas
having a maximum gain of 5 dBi. Antennas having a higher gain are
strictly prohibited per regulations of Industry Canada. The required
antenna impedance is 50 ohms.
DÉCLARATION D’INDUSTRIE CANADA
Le présent appareil est conforme aux CNR d'Industrie Canada
applicables aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas
produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter
tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
Pour les produits disponibles aux États-Unis / Canada du marché, seul
le canal 1 à 11 peuvent être exploités. Sélection d'autres canaux n'est
pas possible.
les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés
uniquement pour une utilisation à l’intérieur afin de réduire les
risques de brouillage préjudiciable aux systèmes de satellites mobiles
utilisant les mêmes canaux.
NOTE IMPORTANTE (POUR L’UTILISATION DE DISPOSITIFS MOBILES):
DÉCLARATION D’EXPOSITION AUX RADIATIONS
Cet équipement est conforme aux limites d'exposition aux
rayonnements IC établies pour un environnement non contrôlé. Cet
équipement doit être installé et utilisé avec un minimum de 40 cm de
distance entre la source de rayonnement et votre corps.
Cet appareil et son antenne (s) ne doit pas être co-localisés ou
fonctionnement en association avec une autre antenne ou
transmetteur.
Ce dispositive a ete concu pour fonctionner ave une antenna cellulaire
ayant un gain maximal de 3 dBi. Une antenne a gain plus eleve est
strictement interdite par les reglemnets d’Industrie Canada.
L’impedance d’antenne requise est de 50 ohms.
Ce dispositive a ete concu pour fonctionner ave une antenna WiFi
ayant un gain maximal de 5 dBi. Une antenne a gain plus eleve est
strictement interdite par les reglemnets d’Industrie Canada.
L’impedance d’antenne requise est de 50 ohms.

Summary of content (2 pages)