User's Manual

NS-CAHBTEP01
Bluetooth Earpods
NS-CAHBTEP01_15-1223_QSG_V0_EN.ai 12/23/2015 15:54:25PM
Bluetooth Earpods
Volume Up
Next Track
USB charging cable
Quick Setup Guide
1
4
3
1 4
1
4
6
6
5
1
7
2
2
2
2
2
2
2
2
2
RIGHT BACK LEFT
Press + to increase the volume.
Press + to Skip to Next Track.
Volume Down
Previous Track
Next Track/
Previous
Track
2
1
Press - to decrease the volume.
Press - to Previous Track.
5 Cable clamp
The Cable clamp on the collar.
6 Micro USB port
Plug the micro USB connector into this port
to charge your headphones.
7 Microphone Allows you to talk on the telephone.
(Power/talk/Play/
Pause/pairing)
button
Press to turn on your stereo headphones.
If you receive a phone call, press to talk. Press
to turm off your stereo headphones .
3 Indicator led Shows current status of the headphones.
Connect the charging cable to
your stereo headphones
Micro USB port, then plug
the USB connector into your
desktop computer, notebook
or Smartphone AC adapter.
The red LED stays on while
your stereo headphones are
charging and turns off when
they are fully charged.
MFB
+
-
2
Press and hold the MFB
button for two/three
seconds . The LED blinks
blue (when turned on) or
red (when turned off), and
the voice prompt says
“Power on”, or “Power off.”
BT basic indication
Bluetooth Function Indication
Charging Indication
Item
Power on Long press MFB more than 2s Blue LED on 1.5s "power on"
Power off Long press MFB more than 3s Red LED on 1.5s "power off"
Pairing
mode
Play/Pause
Long press MFB more than 4s
on power off stage
Short press MFB button
Blue and red LED
blinking alternant
//
/
/
Blue LED blinking 3
times until pick up
/
/
/
Volume Up
/Down
Incoming
call
Answer call
Some ring tone
1 short beeps tone
Short press + / - button
Long press +/ - button
Short press MFB when have
a calling
/Reject call 1 long beeps tone
Long press MFB when have
a calling
/Redial 2 short beeps toneDouble press MFB
Red LED on
Red LED off
Charging /Connected USB cable
Full charging //
Blue LED blinking fast
3 times at every 1min
Low battery
"battery low" at
every 1 min
/
All LED off then
power off
Reset
device list
Long press MFB button more
than 10s in power off stage
/
2 high beeps tone
for max volume
2 low beeps tone
for min volume
2 short beeps tone
Operation LED Indication Tone
Method of use
1. Place Headphone on the neck, insure the same of length of both sides.
2. Place clip on collar which could be keep the Headphone wouldn’t be
drop.
3. Wear the earpods, at that time the controller will nature hang front of
right shoulder.
4