Instruction Manual

LSPFN13WLAN Instruction Manual

Installation and Use of Transceiver Module

Any unauthorized copy, alteration, distribution, transmission, performance, display, or other use of this

material is strictly prohibited.

www.luminsmart.com

PAGE 1
LSPFN13WLAN Instruction Manual Installation and Use of Transceiver Module Copyright Coulomb, Inc. (DBA Lumin) 2021 Any unauthorized copy, alteration, distribution, transmission, performance, display, or other use of this material is strictly prohibited. www.luminsmart.
PAGE 2
LS-100363_REV2 1 Module Installation 1. Ensure pads/pins are clean on host PCB and module. 2. Place module onto host PCB. 3-5. Solder numbered regions in order. 6. Connect antenna of correct type and gain as specified in “Module Use.
PAGE 3
LS-100363_REV2 2 Module Use 2.1 Host Integration Requirements This radio transmitter, FCC ID: 2AY52-LSPFN13WLAN, IC: 27016-LSPFN13WLAN, has been approved by the FCC and Innovation, Science and Economic Development Canada to operate with the antenna types listed below, with the maximum permissible gain indicated. Antenna types not included in this list that have a gain greater than the maximum gain indicated for any type listed are strictly prohibited for use with this device.
PAGE 4
LS-100363_REV2 2.2 Regulatory Statement This device complies with Part 15 of the FCC rules and with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: 1. This device may not cause interference. 2. This device must accept any interference, including interference that may cause undesired operation of the device.