M ANU AL C M-1 8 Pull remote 1 channel English
CM-18 is a pull remote with 1 channel for operating single blinds or shading networks with a simple pull. Blinds can be moved to any desired position. Pull once to move the blinds to the end positions, pull again to stop the blinds. Operating remotely controlled blinds has never been so easy and intuitive: anyone can do it. Channels Max. blinds FreRange quency 1 Unlimited 20 m 433.925 open MHz space Frequency Power Length Width emission supply power ≤2.32dBm 2x LR44 1.5V 19.
Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion. Leaving a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage of flammable liquid or gas. A battery subjected to extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas.
FCC Manual I FCC ID: ZY4CM18 Regulatory Information 1 FCC Information for User This product does not contain any user-serviceable components and is to be used with approved antennas only. Any product changes or modifications will invalidate all applicable regulatory certifications and approvals. 2 FCC Electronic Emission Notices This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference 2.
+ 1 Buttons 2 Changing the battery - LR44 1.5V Pair Button 1 2 1. BUTTONS 2.
3 Pair a remote Repeat steps 3.1 - 3.2 to remove a blind from a channel. 3.1 3.2 3. PAIR A REMOTE Shortly press the program button on the motor. The blind will start stepping, indicating that program mode has been activated. (The blind remains stepping until the program mode is de-activated.) Press the pair button on the remote control to pair the blind to the remote control. The blind will shortly stop stepping indicating that the remote has been paired to the blind. 3.
4 Connect a chain 3 1 4 2 4. CONNECT A CHAIN 4.
5 Attach to a blind Roller blind bracket Roller blind cassette RCU-21 drill a ø 5 mm hole 5. ATTACH TO A BLIND 5.
Roman blind Venetian blind drill a ø 5 mm hole drill a ø 5 mm hole 5. ATTACH TO A BLIND 5.
6 Control After the blind has reached its end position, the consecutive ”STOP” command is eliminated after 60 seconds. The next pull will directly operate the blind. 6.1 6. CONTROL Pull once to move the blind to its end position. 6.2 Pull again to stop the blind. 6.3 6. CONTROL Pull again to move the blind in the opposite direction.
motion-blinds.com CM18U-R3 All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form, by any means, electronic, mechanical, photocopying, recording, digital or otherwise without the written permission of the publisher. Although this manual has been composed with the utmost care, Coulisse b.v. does not accept any responsibility for damage due to mistakes and/or faults in this manual. Coulisse b.v.