Wall remote 1 channel English M ANU AL CM-15
CM-15 is a wall remote with 1 channel for operating and programming blinds at the push of a button. Blinds can be moved to any desired position or to a preset favourite position. The remote control can be used separately from the wall plate as as a hand-held remote separately. Channels Max. blinds 15 Unlimited Frequency Range 433.925 MHz 30 m with 1 concrete wall Frequency Power emission supply power ≤2.32dBm CR2430 3.
Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion. Leaving a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage of flammable liquid or gas. A battery subjected to extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas.
FCC Manual I FCC ID: ZY4CM15 Regulatory Information 1 FCC Information for User This product does not contain any user-serviceable components and is to be used with approved antennas only. Any product changes or modifications will invalidate all applicable regulatory certifications and approvals. 2 FCC Electronic Emission Notices This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference 2.
The center button has two functions: press to stop the blind, hold to move the blind to its favorite position. 1 Buttons 2 Activate the remote Indicator Up Left Centre (stop/favourite) Right Down 1. BUTTONS Pair button 2.
3 Changing the battery When the indicator is flashing at a high frequency, the battery needs to be replaced. 3 2 1 + Click! Click! - CR2430 3,0V 3. CHANGING THE BATTERY 3.
Different materials require different types of fittings. Always choose screws and plugs that are specially suited to the material. 4 Remote holder PICO-WBX-ADAPT (ABC-27) Claro wallplate (ABC-27) 4. REMOTE HOLDER Claro wallplate (ABC-27) 4.
5 Pair a remote Repeat steps 5.1 - 5.2 to remove a blind from a channel. 5.1 5.2 5. PAIR A REMOTE Shortly press the program button on the motor. The blind will start stepping, indicating that program mode has been activated. (The blind keeps stepping until the program mode is deactivated) Press the pair button on the back of the remote control to pair the blind with the remote control. The blind will shortly stop stepping, indicating that the remote has been paired with the blind. 5.
motion-blinds.com CM15U-R3 of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form, by any means, electronic, mechanical, photocopying, recording, digital or otherwise without the written permission of the publisher. Although this manual has been composed with the utmost care, Coulisse b.v. does not accept any responsibility for damage due to mistakes and/or faults in this manual. Coulisse b.v.
