MOTION CM-08 LI-ION END MOTOR MOTION CM-08 LI-ION END MOTOR CM-15 1 Channel Wall Remote Up Left Centre (stop/ favourite) CM-16 4 Channel Wall Remote Up CM-18 1 Channel Tassel Remote CM-20 Motion Bridge Down Centre (stop/ favourite) English Right Down Pair Button Pair Button Pair Button See manual CM-20
MOTION CM-08 LI-ION END MOTOR MOTION CM-08 LI-ION END MOTOR 1 Install the blind 5 Pair a remote Pair a remote control that is able to program blinds. See pages 4 and 5 for remote controls details. In this manual CM-12 is displayed. 2 Click! 5.1 2.1 2.2 2.3 Click! 5.2 5.3 Channel Indicator Select a desired channel for the blind using the channel selection button on the remote control. Press the pair button on the back of the remote control to pair the blind to the selected channel.
MOTION CM-08 LI-ION END MOTOR 7 Set bottom position MOTION CM-08 LI-ION END MOTOR 9 Set top position 7.1 Down Press and hold the down button until the blind reaches the desired bottom position. WARNING: Risk of damage. Slowly approach the bottom position. Up 9.1 Press and hold the up button until the blind reaches the desired top position. WARNING: Risk of damage. Slowly approach the top position. English 8 10 Centre Up 8.
MOTION CM-08 LI-ION END MOTOR 11 Set favourite position (optional) MOTION CM-08 LI-ION END MOTOR 13 Operate the blind Pull control: Pull once to move the blind to the end positions. Pull again to stop the blind. Centre Centre 11.1 Move the blind to a desired favourite position. 11.2 Channel Selection Up Down Remote control: Choose the channel to which the blind has been paired using the channel button. Press the up or down button to operate the blind. Press the centre button to stop the blind.
MOTION CM-08 LI-ION END MOTOR 15 Reset favourite position MOTION CM-08 LI-ION END MOTOR 17 Reset the blind It is possible to only delete end limits or to do a factory reset. Factory reset will delete the end limits and remove the connection to any paired remote. 15.1 Move the blind to a desired favourite position. Centre 15.2 Press the program button on the motor to activate program mode. The blind starts stepping. 15.3 Hold the centre button to save this favourite position.