Corning® StackSENSE™ Imaging Base Instruction Manual Catalog Numbers: Cat. # Features StackSENSE System for Process Development, Standalone version, 6880 Includes 1 user license, 3 Imaging Bases, computer and network assembly for 1 incubator.
Insert a TABLE OF CONTENTS Page Safety Information To avoid personal injury while using the Corning® StackSENSE™ System: ◗ Do not attempt to remove or repair the outer case of the unit. ◗ Never attempt to repair, disassemble, or modify this unit yourself, as tampering with this product may result in injury. ◗ Do not drop the unit or allow objects to fall onto it. ◗ Do not allow the unit to be submerged or immersed in liquid. ◗ Do not stand or lean on the unit. Doing so may result in breakage and/or injury.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. MPE Requirements Operation Frequency: 2400 - 2483.5 MHz RF power:<20dBm To satisfy FCC / IC / EU RF exposure requirements, a separation distance of 20 cm or more should be maintained between the antenna of this device and persons during device operation. To ensure compliance, operations at closer than this distance is not permitted.
1. Corning StackSENSE Imaging Base 2. Corning CellSTACK vessel (2-layer to 40-layer vessels) 3. StackSENSE software and networking equipment 4.0 Diagram of Corning StackSENSE Imaging Base: Figure 1. Schematic of Corning StackSENSE Imaging Base. Figure 2.
illuminate a fixed field of view and then capture a high-quality image of the attached cells. The optical assemblies are designed to properly align with the bottom surface of a CellSTACK vessel and do not require focusing by the user. 6.0 Charging the StackSENSE Imaging Base battery: SAFETY WARNING – Use only the original or Corning-authorized replacement battery for the Imaging Base To charge while the battery is installed within the StackSENSE Imaging Base: 1.
1. During power on: The Imaging Base will capture a set of images each time that the unit is manually powered on. 2. Scheduled via software: The Imaging Base will capture images according to a custom schedule that the user creates in the “Build Protocol App”. This section describes the process that occurs each time the Imaging Base captures a set of images. i. First, the LED indicator will start flashing green slowly for approximately 30 seconds.
◗ Dimensions Length 33.5 cm (13.2 inches) Width 20.5 cm (8.1 inches) Height 3.0 cm (1.2 inches) (4.0 cm (1.6 inches) including the alignment features) ◗ Weight 1.2 Kgs (2.6 lbs.) Battery Life ◗ The Imaging Base will capture >900 images on a full charge (1 image capture cycle/4 hours for 30 days).
in original material or workmanship. This warranty does not cover motor brushes, fuses, light bulbs, batteries or damage to paint or finish. Claims for transit damage should be filed with the transportation carrier. In the event this product fails within the specified period of time because of a defect in material or workmanship, contact Corning Customer Service at: USA/Canada 1.800.492.1110, outside the U.S. +1.978.442.2200, visit www.corning.com/lifesciences, or contact your local support office.