User's Manual

•

RxU

Remote Expansion Unit

Quick Installation Sheet

Corning ONE

™

Wireless Platform

CMA-261-AEN

QUICK INSTALLATION SHEET | CMA-261-AEN | JULY 2013 | PAGE 1 OF 2

GENERAL INFORMATION

1. RxU expands the RAU band support to two additional MIMO bands.

2. RxU is assembled in the RAU enclosure (hot pluggable).

Unit

1. PACKAGE CONTENTS

Check your package contents to verify that the items in the packing list are included:

Item Quantity Item

Remote Expansion Unit (RxU) 1

2. ASSEMbLE Rxu IN RAu ENCLOSuRE

Note: There is no need to disconnect the composite

  cableberandDCwiresleadingfromthe 

ceiling.

Step 1: Remove the screw securing the bracket safety

tab to the RAU (located above MGMT port).

Step 2: Slide the RAU back into wide end of bracket

screw holes so that it “clicks,” and remove unit.

Step 3: Unscrew(ve)screwssecuringtheRAU 

enclosure cover and remove cover.

See Figure 1 for location of screws.

Figure 1. Removing RAU Enclosure Cover

ONE

™

Wireless Platform

This document describes the installation procedure for the ONE

™

Remote Expansion Unit (RxU).

Remove Front Flap

Remove Three Screws

Remove

Screw

Remove

Screw

PAGE 1
RxU Remote Expansion Unit Quick Installation Sheet Corning ONE™ Wireless Platform CMA-261-AEN GENERAL INFORMATION 1. 2. RxU expands the RAU band support to two additional MIMO bands. RxU is assembled in the RAU enclosure (hot pluggable). This document describes the installation procedure for the ONE™ Remote Expansion Unit (RxU). 1. PACKAGE CONTENTS Check your package contents to verify that the items in the packing list are included: • Item Quantity Remote Expansion Unit (RxU) Item 1 2.
PAGE 2
Step 3: Plug the RxU in to the right side of the RAU as indicated in Figure 2. RxU and RAU interface ports should face the same direction. Step 4: 3. RxU Module Replace the cover except for the front panel and screws, as shown in Figure 3 RF CONNECTIONS If required by site planner – connect the filter to the RF filter connectors on the RxU. Refer to Figure 3 for location of RAU and RxU filter connections. Figure 2.