IoT Device (CST-G001) Manual 25th Oct 2019 US Representative Contacts Company name : Corners Global Address : 3949 Eden St, Philadelphia, PA 19114 Contact Name : Adel Ebeid
Contents 1. OVERVIEW ...................................................................................................................................................................... 3 2. INSTALLATION ............................................................................................................................................................... 5 2.1 CONNECTION GUIDE ...........................................................................................................................
1. OVERVIEW - CST-G001 is a device installed at the entrance and top of the wall of each floor of the building. - CST-G001 checks the surrounding noise real-time and passes the detected dB value and detection angle information to CST-N001. - Subsequently, evacuation information is received from CST-N001 and evacuation direction is notified and broadcast to minimize casualties.
Specification Parameter Description CPU STM32L100RB,ARM 32-bit Cortex™-M3, 128Kbytes RF LoRaTM long range modem,900MHz Audio PCM방식, Sample Rate 22kHz,16bit mono, 3W LED Beam White LED LED Green, Red LED Gun Sensor ARM9, 32bit RESC Core Mic Mic * 2 Power Input : AC 120V /60Hz Battery 3.
2. INSTALLATION Introduce the installation method of CST-G001 2.1 Connection Guide - CST-G001 is a LoRa-based wireless equipment designed to be installed with factory default values. No setup work is required when installing. (Setups change settings remotely through CST-N001.) 2.2 First-Time Power On - Power SW on the back of the product should be off. - Always connect 120V of power to the AC connector on the back of the product. - Power SW on.