Coretronic Corporation 802.11n, Dual Band, 2T2R Wireless LAN PCI Express Half Mini Module WN6500RH User Manual This document contains confidential proprietary information and is property of LTC. The contents of this document should not be disclosed to unauthorized persons without the written consent of LTC. Change History: Revision Version 1.0 Version 1.1 Version 1.
PRODUCT FEATURES Operate at ISM frequency bands (2.4 / 5 GHz) IEEE standards support: IEEE 802.11a, 802.11b, 802.11g, 802.11n The WN6500RH is developed using single-chip designed by Ralink Technology Corporation PCI Express Half Mini Module USB interface Complies with USB Specification 2.
Channel Table WLAN 2.4GHz 13 Channels are provided for 802.11b,802.11g and 802.11n (20MHz) CHANNEL RFEQUENCY CHANNEL FREQUENCY 1 2412MHz 8 2447MHz 2 2417MHz 9 2452MHz 3 2422MHz 10 2457MHz 4 2427MHz 11 2462MHz 5 2432MHz 12 2467MHz 6 2437MHz 13 2472MHz 7 2442MHz 9 Channels are provided for 802.
WLAN 5.18 ~ 5.32GHz 8 channels are provided for 802.11a,802.11n (20MHz) CHANNEL RFEQUENCY CHANNEL FREQUENCY 36 5180MHz 52 5260MHz 40 2200MHz 56 5280MHz 44 5220MHz 60 5300MHz 48 5240MHz 64 5320MHz 4 channels are provided for 802.11n (40MHz) CHANNEL RFEQUENCY CHANNEL FREQUENCY 38 5190MHz 54 5270MHz 46 5230MHz 62 5310MHz WLAN 5.50 ~ 5.70GHz 11 channels are provided for 802.11a,802.
Install the Hardware 1. Insert the Device WN6500RF inside the USB test board . 2. The system will automatically dectect the new hardware.
n ra tio Li te O n Te ch no lo gy C or po 1.
lo gy C or po ra tio n 2. Choose “Browse my computer for device software” Li te O n Te ch no 3.
lo gy C or po ra tio n 4. “Have Disk” Li te O n Te ch no 5.
ra tio n 6. Choose your OS type and enter the folder, then double click the inf file inside Li te O n Te ch no lo gy C or po 7.
no lo gy C or po ra tio n 8. The file name is “RT5572 QA Test USB WDM Driver”, then click “Next”, driver will be installed right away Li te O n Te ch 9.
Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna. As long as 2 conditions above are met, further transmitter test will not be required.