User's Manual

ManualsBrandsCorecess ManualsElectronicsVDSL Modem

| FCC Part 15 Notice |

This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to part 15 of the

FCC Rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful interference,

and (2) this device must accept any interference received,

including interference that may cause undesired operation.

Class B limits are designed to provide reasonable protection

against harmful interference in a residential installation. This

equipment generates, uses, and can radiate radio frequency

energy, and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio

communications. However, there is not guarantee that

interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or

television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

•

Reorient the receiving antenna.

•

Increase the separate between the equipment and the

receiver.

•

Connect the equipment into an outlet on a circuit

different from that to which the receiver is connected.

•

Consult the dealer or an experienced radio/TV technician

for help.

CAUION: Changes or modifications not expressly

approved by the manufacturer responsible for

compliance could void the user's to operate the

equipment.

| Copyright |

ⓒ

No Part of this book shall be reproduced, stored in a

retrieval system, or transmitted by any means, electronic,

mechanical, photocopying, recording, or otherwise,

without written permission from the publisher.

The specifications and information regarding the products

in this manual are subject to changed without notice.

| Trademark Credit |

Corecess 3213 is registered trademark of Corecess Inc.

Windows is registered trademark of Microsoft Corp.

Corecess Inc.

997-4, Daechi-dong, Kangnam-ku, Seoul, Korea

TEL:82-2-3016-6900 FAX:82-2-3016-6622

http://www.corecess.com

Summary of content (11 pages)

PAGE 1
| FCC Part 15 Notice | This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Class B limits are designed to provide reasonable protection against harmful interference in a residential installation.
PAGE 2
Thank you for using the product of Corecess. the Corecess VDSL Modem Corecess 3213.
PAGE 3
Introduction The Corecess 3213 is an Very-high-data-rate Digital Subscriber Line (VDSL) modem used for home connectivity to an VDSL service provider network over an Ethernet network connection. The Corecess 3213 VDSL modem can transmit and receive data at rates up to 16Mbps. Unpacking the Box Check the shipping carton carefully to ensure that the contents include the items you ordered.
PAGE 4
Installing the Corecess 3213 Connecting Cables E nglis h n Connecting the VDSL Line (LINE Port) Connect the provided VDSL cable to the LINE port of the Corecess 3213 and then connect the other end of the cable to the wall receptacle. o Connecting a Telephone (PHONE Port) Connect a telephone cable to the PHONE port of the Corecess 3213 and then connect the other end of the cable to your telephone.
PAGE 5
Power on the Corecess 3213 After connecting the Corecess 3213, turn on the Corecess 3213 by pressing the power switch on the rear panel of the Corecess 3213. When you have powered up the Corecess 3213, check the status of the four LEDs on the front panel by the following table: LED Color POWER Status Description ON DC power is being supplied to the Corecess 3213. ON The modem is connecting to VDSL network. LAN ON The LAN port is connecting to Ethernet port on your PC.
PAGE 6
Configuring the TCP/IP After you install the Corecess 3213, next is to configure the TCP/IP network protocol. Windows 95/98/ME 1. Click the Start button and select Settings ¼ Control Panel. (Figure 1) 2. Double-click the Network icon. Figure 1 3. Select TCP/IP in the ‘The following network components are installed’ list and click Properties. (Figure 2) 4. Select the [IP Address] tab and click the Obtain IP address automatically. (Figure 3) 5.
PAGE 7
Windows 2000/NT 1. Click the Start button and select Settings ¼ Network and Dial-up Connections. (Figure 1) Figure 1 2. Right-click the Local Area Connection icon at the windows and select Properties menu. (Figure 2) Figure 2 3. At the dialog box, select the Internet Protocol (TCP/IP) in the ‘Components checks are used by this connection’ list and click Properties. (Figure 3) 4.
PAGE 8
Windows XP 1. Click the Start button and select Settings menu. (Figure 1) icon at the E nglis h 2. Double-click the Network window. Figure 1 3. Right-click the Local Area Connection icon at the windows and select Properties menu. (Figure 2) 4. At the dialog box, select the Internet Protocol (TCP/IP) in the ‘This connection uses the following items’ list and click Properties. (Figure 3) Figure 2 5.
PAGE 9
Troubleshooting If you cannot connect to VDSL network, please check the status of the LEDs on the front panel, and then ensure the following: 1. Check the LAN LED If the LAN LED goes off, ensure that the Ethernet cable is firmly connected both to the Ethernet port on the Corecess 3213 and LAN port on your PC. 2. Check the LINK LED If the LINK LED blinks continuously and never stays solid on, ensure that the VDSL cable is firmly connected to the LINE port on the Corecess 3213.
PAGE 10
Windows 2000/NT/XP n Click the Start button and select Run. p The DOS-prompt appears. Input ipconfig /release and press [Enter] key. E nglis h q Input ipconfig /renew and press [Enter] key. o Input cmd and press the [Enter] key. 4. Restart your PC If new IP address is not assigned properly or you cannot solve the problem, ensure that the Corecess 3213 turns on and then restart your PC.
PAGE 11
Technical Specifications Description Specification VDSL Standard y ETSI VDSL Standard Standard y ANSI VDSL Standard y ITU VDSL Standard IEEE Standard y IEEE 802.3 10/100Base-TX Ethernet y 10/100Base-TX (IEEE 802.3) y Connector: RJ-45 VDSL Line Interface y Line Code: Quadrature Amplitude Modulation (QAM) QAM 4 - QAM 256 configurable y Up/Downstream: 16Mbps y Duplexing scheme: Frequency Division Multiplexing (FDD) y Band allocation: 3.94 – 8.26 MHz (Upstream) 0.64 – 3.