Installation Guide

Page 1 of 2 190412ID
109-719 19LT DOLCE PENDANT INSTALLATION INSTRUCTIONS
WARNING
DISCONNECT POWER BEFORE RELAMPING OR WIRING THE FIXTURE.
READ ALL INSTRUCTIONS COMPLETELY BEFORE STARTING INSTALLATION.
CAUTION
TO AVOID THE RISK OF FIRE OR SHOCK, FIXTURE MUST BE INSTALLED IN COMPLIANCE WITH ALL APPLICABLE NATIONAL AND LOCAL
ELECTRICAL/BUILDING CODES.
INSTALLATION AND MAINTENANCE OF THIS UNIT REQUIRES AN ELECTRICIAN OR CERTIFIED FACTORY TRAINED TECHNICIAN.
If an existing fixture is being replaced, remove it and note to which of the wires in the outlet box the fixture was attached. DO NOT SEPARATE
ANY OTHER WIRES THAT MAY BE IN THE BOX. DO NOT DAMAGE THE INSULATION OF OLDER WIRING. In regular circumstances the BLACK
wire will be the “Hot” lead and the WHITE wire will be the “Neutral” or “Common” lead. A GREEN or BARE COPPER wire is the “Ground”. In
older buildings, it is always good practice to reconfirm the polarity of the wiring.
NOTICE
The important safeguards and instructions outlined on this sheet
cannot cover all possible conditions and situations that may occur.
It must be understood that common sense, caution and care are
factors that cannot be built into any product. Caution and care must
be supplied by the person(s) installing, operating and caring for
this lighting fixture.
This fixture is designed to be mounted on a correctly installed
standard round or octagon box or a through wiring box with a
plaster frame. The box must be securely mounted to the structure
of the building. The crossbar and hardware supplied should be
used. Directly mounting the fixture to the outlet box may make it
impossible to correctly align the fixture.
This fixture is supplied with a 4-piece stem. There is one 6"
section, 2 12" sections and one 18" section. This feature allows the
fixture to be mounted with a stem up to 48" in length in 6"
increments.
This fixture is supplied with a double loop. This allows the fixture
to hang straight even when mounted to an angled ceiling.
FIXTURE PREPARATION
1. Remove the fixture and parts bag(s) from the carton.
NOTICE:
Before discarding the carton, double check the contents
to make certain that all parts are found.
2. Determine the overall desired length of the fixture. Thread the leads and ground wire
through each stem section and the loop at the top as they are assembled.
3. Measure 6” of lead wire beyond the top of the screw collar loop. Cut off the excess wire.
Strip the insulation off the ends of the leads exposing approximately ½” of wire.
Twist the strands of wire together.
FIXTURE INSTALLATION
1. Thread the nipple into the crossbar and the nut onto the nipple. Attach the crossbar to the outlet box. (The green screw should face the floor.)
2. Adjust the nipple so that it extends ¼” beyond the canopy. Lock the hex nut against the crossbar. Thread the screw collar loop onto the nipple.
Outlet box
Green Screw
Crossbar
Canopy
Stem
Nipple
Hex nut
Open chain link
Top loop
Ring

Summary of content (2 pages)