C-One² QSG 180190 B00 Quick Start and Regulatory Guide Siège social 185 avenue Archimède 13857 Aix-en-Provence Cedex 3 • France • Tel.
C-One² QSG 180190 B00 Quick Start and Regulatory Guide COPPERNIC C-One² LF AGRIDENT C-One Product Overview LED Indicators (P2) Microphone Scanner Hand Strap Holder Flash Camera NFC/RFID Area Speaker www.coppernic.
C-One² Quick Start and Regulatory Guide QSG 180190 B00 Setting up your phone MICRO SIM CARD INSTALLATION Open Micro SD/Micro SIM door. To remove the Micro SIM card: Insert a removal tool (pin type) into the hole then push until the tray pops out. Put the Micro SIM card on the tray. Insert Micro SIM tray into SIM slot. Close the door after installation. MICRO SD CARD INSTALLATION ® Open Micro SD/Micro SIM door. ® Insert Micro SD card into Micro SD card slot. ® Close the door after installation. www.
C-One² Quick Start and Regulatory Guide Caution: Failure to completely reseal the SIM/microSD card slot cover may lead to water or other liquids entering the casing, which may cause damage to the phone. Note: Micro SIM card and Micro SD card should be purchased separately. www.coppernic.
C-One² Quick Start and Regulatory Guide QSG 180190 B00 CHARGE THE BATTERY Before using the C-ONE², charge the battery using one of the following accessories approved by COPPERNIC: Micro USB cable + Power Adaptor Jack (included in package) and insert the cable to Micro USB hole Cradle Charging + DC Power Cable + Power Adaptor Jack www.coppernic.
C-One² QSG 180190 B00 Quick Start and Regulatory Guide LED INDICATORS LED1 LED2 Red LED blinks (LED1) Low battery Red LED (LED1) Battery is charging Green LED (LED1) Battery is fully charged Blue LED blinks (LED2) BT devices connected or receiving messages/notifications CAUTION: Please make sure the device being charged fully when using C-ONE² at first time. Please ensure the Micro USB port clean and dry before inserting a USB cable for charging to avoid the operating issues on the device.
C-One² Quick Start and Regulatory Guide QSG 180190 B00 Using Your Phone TURNING ON/OFF YOUR PHONE To turn on the phone, press and hold the power button during 5s. To turn off the phone, press the power button and select “Power off” in the dialog box. To reset the phone, press and hold the power button during 30s. Note: Device turns to the modes as below by pressing power button key. u Suspend Mode Press and release the power button to place the device in suspend mode.
C-One² QSG 180190 B00 Quick Start and Regulatory Guide Using barcode scanning reader as keyboard input: 1. Tap “Demo” apk -> Tap -> Select “Settings” -> Enable “Keyboard Simulation” to replace physical key input on keyboard with scanning input. 2. Choose barcode symbolizes Tap “Demo” apk -> Tap -> Select “Settings” -> Tap “Enable/Disable” under symbology configuration -> Tap “Symbology Config”. Note: Please remove the protector film before using scanner. CAUTION: CLASS 2 LASER WHEN OPEN.
C-One² Quick Start and Regulatory Guide QSG 180190 B00 For C-One² LF AGRIDENT with RFID option, to read put the TAG/CARD on the RFID area. RFID Reading area RFID Reading area (Option: Stick LF AGRIDENT antenna) PHOTO & VIDEOS Using the rear camera to take photos and capture video. 1. Go to Home Screenà select “Camera”à Tap camera icon or screen to take a picture/switch to video icon and tap for video recording. 2. Using the rear camera to take photos and capture video.
C-One² QSG 180190 B00 Quick Start and Regulatory Guide Regulatory Information Caution: Only use COPPERNIC approved accessories.
C-One² QSG 180190 B00 Quick Start and Regulatory Guide 802.11b : 15.83 802.11g : 16.72 802.11n HT20 (2.4GHz) : 16.76 802.11n HT40 (2.4GHz) : 15.83 802.11a : 15.13 802.11n HT20 (5GHz) : 15.17 802.11n HT40 (5GHz) : 15.30 802.11ac VHT80 : 14.82 Bluetooth : 2.
C-One² QSG 180190 B00 Quick Start and Regulatory Guide LTE Band 7 : 23.97 LTE Band 8 : 23.99 LTE Band 20 : 23.99 LTE Band 28 : 23.94 802.11b : 15.83 802.11g : 16.72 802.11n HT20 (2.4GHz) : 16.76 802.11n HT40 (2.4GHz) : 15.83 802.11a : 15.13 802.11n HT20 (5GHz) : 15.17 802.11n HT40 (5GHz) : 15.30 802.11ac VHT80 : 14.82 Bluetooth : 2.36 Note: C-ONE²: Maximum reported SAR value (10g) Body: 1.71W/kg @5mm C-ONE²(EU): Maximum reported SAR value (10g) Body: 1.99W/kg @5mm 1.
C-One² Quick Start and Regulatory Guide QSG 180190 B00 This device incorporates the international roaming feature which will ensure the product operates on the correct channels for the particular country of use. 4. Ad-Hoc Operation (5GHz Band) Ad-Hoc operation is limited to Channels 36- 48 (5150 – 5250 MHz). Use of this band is restricted to indoor use only, any other use will make the operation of this device illegal.
C-One² Quick Start and Regulatory Guide QSG 180190 B00 Power Adaptor 1. Use only a C-ONE² approved Power Adaptor with electrical ratings: Output 5VDC, min 2A, with a maximum ambient temperature of at least 45°C. 2. Use of alternative power adaptor will invalidate any approvals given to this device and maybe dangerous. Battery Information Use only a COPPERNIC approved batteries. When devices are stored over six (6) months without use, some irreversible deterioration in overall battery quality may occur.
C-One² QSG 180190 B00 Quick Start and Regulatory Guide 11. Battery usage by children should be supervised. 12. Please follow local regulations to promptly dispose of used re-chargeable batteries. 13. Do not dispose of batteries in fire. 14. Seek medical advice immediately if a battery has been swallowed. In the event of a battery leak, do not allow the liquid to come in contact with the skin or eyes. If contact has been made, wash the affected area with large amounts of water and seek medical advice.
C-One² Quick Start and Regulatory Guide QSG 180190 B00 FCC Statement 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
C-One² Quick Start and Regulatory Guide QSG 180190 B00 power output. Before a phone model is available for sale to the public, it must be tested and certified to the FCC that it does not exceed the limit established by the government adopted requirement for safe exposure. The tests are performed in positions and locations (e.g., at the ear and worn on the body) as required by the FCC for each model. The highest SAR value for this model phone when tested for use at the ear is 0.
C-One² Quick Start and Regulatory Guide QSG 180190 B00 These requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR value for this model phone when tested for use at the ear is 0.308/Kg and when worn on the body is 0.749/Kg. The maximum scaled SAR in hotspot mode is 0.749/Kg.This device was tested for typical body-worn operations.