INSTRUCTION MANUAL 11 ft x 11 ft Pop up Gazebo with Sidewall
WARRANTY Please read and save these instructions before attempting to set up this gazebo. 1 Year Limited Warranty We warrant for a period of 1 year from the original date of purchase, this product against any defect in materials or workmanship. At its discretion, we may provide replacement parts to original purchaser. Original receipt or proof of purchase as well as proof of defect is required. We will not be responsible for shipping costs incurred outside the continental USA.
OPEN THE GAZEBO FRAME Step 1 You will need: Gazebo Frame 1X ● Work with a partner pull on opposite corners of the frame to extend slightly. ● Remove protective wrap from center arms. Pivot plastic arms up.
ATTACH THE SMALL GAZEBO TOP Step 2 You will need: Small Top 1X ● Place the small gazebo top on the frame and insert ends of plastic arms into corner pockets of the top.
ATTACH THE BIG GAZEBO TOP Step 3 You will need: Big Top 1X Eave Extender 4X ● Place the big top on the frame, and pull the triangle holes on each corner of the top towards the leg cap and position over the corner of the frame. ● Pass the eave extender though the corner hole in the big gazebo top and insert into the leg cap at each corner of the frame. Make sure all the eave extenders are clicked into place.
LOCK THE GAZEBO FRAME Step 4 ● Finish attaching the big top by tying the ropes from the small top to the big top. ● Work with your partner, grasp the gazebo frame at opposite corners and walk backwards to extend the frame. Then lift up the lower eave near the leg while pushing down on the top of the leg. The leg slider will move up and lock into place.
ADJUST THE GAZEBO HEIGHT Step 5 ● Attach the big top to ceiling assembly by using Velcro connections from inside. ● Lift two adjacent legs, press the push pin on both legs and raise or lower to adjust the gazebo heights. ● Extend the other two legs, press the push pin on both legs and raise or lower to adjust the gazebo height. Velcro Extend Extend 4x 2x Tips: It is recommended to lower to the lowest height to hang up the side wall.
ATTACH THE SIDE WALL Step 6 You will need: Side Wall 4X ● Attach the side wall to the eaves by using the Velcro straps. Make sure the zipper of the side wall is located in the middle of the eave assembly, and the side wall is outside of the frame, but between the leg and leg skirt. ● Secure the side wall to the adjacent frame legs by attaching the Velcro straps.
TIE BACK THE SKIRT & SIDE WALL Step 7 ● Tie back the leg skirt without the side wall. ● Tie back the leg skirt and the side wall together using ties sewn into the leg skirt.
SECURE THE GAZEBO IN PLACE Step 8 You will need: Stake 8X ● Insert the hooks sewn in the leg skirts into the bottom holes of the gazebo legs. ● Insert two stakes into each footpad to secure your gazebo in place. ● Attach the sand weight bag to each leg of canopy using the three Velcro connections.
SECURE THE GAZEBO IN PLACE Step 9 You will need: Big Stake 4X Guy Rope 4X ● Attach the guy ropes to the plastic rings sewn in corners of the gazebo top. ● Use the guy ropes to measure the proper distance from each leg to secure four stakes in the ground. Ensure the ropes have proper tension.
TAKE DOWN THE GAZEBO 1 2 Retract the legs to the original Remove the weight bags, pull up all stakes, release the hooks, remove the guy ropes. height by pushing the push pin. Push Velcro Side Wall 4 Push the push button on each slider 3 Remove the side walls if attached. to unlock the frame. Pull 5 Push inward until the frame is fully closed. 6 Remove the eave extender . 11 7 Put the closed gazebo and side wall into the carry bag.
REPLACEMENT PARTS Spare Parts To inquire about replacement parts, please email to teamaftersale@outlook.com.