User's Manual

ManualsBrandsCooper Wiring Devices ManualsElectronicsRF Single Pole Switch

To install:

Connect wires per wiring diagram as follows:

Load

Charge

Carga

Neutral

Neutre

Neutro

Hot

Phase

Vivo

Neutral

Neutre

Neutro

(Ground) Green

(Terre) Verte

(Tierre) Verde

White

Blanc

Blanco

Black

Noir

Negro

Red

Rouge

Rojo

• Remove pre-stripped insulation on device wires.

• Strip wires in box 1/2”.

• Twist ends of stripped wires together as per schematic.

• Twist on wire connectors clockwise until secure.

• Connect green ground wire to bare wire, and mount to box with screws.

After completing successful installation LED on device will blink until programmed.

For detailed programming instructions for your Switch, refer to the ASPIRE RF manual

that is included with the Handheld (RFHDCSG) or Table Top (RFTDCSG) Controller.

FEDERAL COMMUNICATIONS COMMISSION

INTERFERENCE STATEMENT

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

1: This device may not cause harmful interference, and

2: This device must accept any interference received, including interference that

may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for

a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference in a residential installation.

This equipment generates uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications.

Summary of content (2 pages)

PAGE 1
To install: Connect wires per wiring diagram as follows: Neutral Neutre Neutro White Blanc Blanco Black Noir Negro Hot Phase Vivo Load Charge Carga Red Rouge Rojo (Ground) Green (Terre) Verte (Tierre) Verde Neutral Neutre Neutro • Remove pre-stripped insulation on device wires. • Strip wires in box 1/2”. • Twist ends of stripped wires together as per schematic. • Twist on wire connectors clockwise until secure. • Connect green ground wire to bare wire, and mount to box with screws.
PAGE 2
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver.