User Manual of CS3156 RTLS sensor 1
FCC Regulations: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
RF Exposure Information This device meets the government’s requirements for exposure to radio waves. This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the U.S. Government. This device complies with FCC radiation exposure limits set forth for an uncontrolled environment.
Table of Content User Manual of .............................................................................................................. 1 CS3156 RTLS sensor ..................................................................................................... 1 Introduction .................................................................................................................. 5 1 Product Description and installation Procedure ............................................... 6 1.1 CS3156.....
Introduction The CSL RTLS solution is based on the application of time of arrival technology. In the RTLS, an anchor is the device installed in a known position inside a zone, normally, at the corners of the zone. The moving sensors within the zone can measure the range to each anchor so as to obtain the absolute positions inside the zone. In a minimum RTLS system, 4 anchors are installed in a zone. However, the more the anchors are installed, the higher the accuracy of the sensor position to be obtained.
1 1.1 Product Description and installation Procedure CS3156 1.1.1 Product Description CS31516 is a battery-operated RTLS sensor. Rechargeable Lithium Polymer batteries are installed for normal function. Charging interface is a 2-pin connector via a charging cable to USB type A interface. The charging voltage is +5VDC+/-10%. 1.1.2 Installation Procedure Batteries are preinstalled in factory. CS3156 wakes up for a short period during each regular interval.
1.1.
