User Manual of CSL RTLS System CS3151BB2 Tag CS5111LP Reader CS5113LP Reader with Ethernet Bridge 1
FCC Statement FCC NOTICE: To comply with FCC part 15 rules in the United States, the system must be professionally installed to ensure compliance with the Part 15 certification. It is the responsibility of the operator and professional installer to ensure that only certified systems are deployed in the United States. The use of the system in any other combination is expressly forbidden.
Table of Content User Manual of CSL RTLS System ...............................................................................1 Introduction..................................................................................................................4 1 System Component Description..........................................................................5 1.1 CS3151BB2 ...............................................................................................5 1.1.1 1.1.2 1.1.3 1.1.
Introduction The CSL RTLS solution is based on the application of time of arrival technology. In the RTLS, an anchor is the device installed in a known position inside a zone, normally, at the corners of the zone. The moving tag inside the zone can measure the range to each anchor so as to obtain its absolute position inside the zone. A Zone Anchor Anchor Tag Anchor Anchor In a minimum system, 4 anchors – 3 normal anchors CS5111LP and 1 master anchor CS5113LP- are installed in a zone.
1 System Component Description 1.1 CS3151BB2 1.1.1 Product Description CS3151BB2 is a battery-operated active RFID tag. Rechargeable Lithium Polymer batteries are installed for normal function. Charging interface is a micro USB connector. CS3151BB2 are designed so that they can be worn on the wrist of human body to track the postion of the moving object. There is a button at the front panel of the tag for various emergency applications. Light indicators are located on the bottom side. 1.1.
1.1.
Weight 0.
Antenna2 : Electrical Items Specifications Model W3108 Type of antenna SMD type Frequency range 2400MHz – 2500MHz Nominal impedance 50 ohm Polarization Linear V.S.W.R 1.5 typically, mounting on CS3151BB2 Gain 1.5dBi typically, CS3151BB2 Mechanical Items mounting on Specifications Dimension in millimeter 5(W) x 2.5(L) x 5.5(H) Weight 0.
1.2 CS5111LP 1.2.1 Product Description CS5111LP is the RTLS anchor( or reader). It integrates the high gain 2.4GHz ISM band antenna and the electronics PCB into one housing for robustness and easy installation. CS5111LP is designed to be mounted at the back panel. 1.2.2 Installation Procedure CS5111LP can be fed with DC voltage ranges from 12V to 34Vdc. The dc plug is 2.5mm locked type. CS5111LP is fully programmed and ready for normal operation once power is on.
1.2.
1.3 CS5113LP 1.3.1 Product Description CS5113LP is the RTLS master anchor( or reader). It integrates the high gain 2.4GHz ISM band antenna and the electronics PCB into one housing for robustness and easy installation. CS5113LP has Ethernet connectivity function to communicate with the server application. CS5113LP is also a POE PD that can allow it to be powered through IEEE 802.3 certified PSE. 1.3.2 Installation procedure CS5113LP can be fed with DC voltage ranges from 12V to 34Vdc. The dc plug is 2.
1.3.
Federal Communications Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
