User Manual of CSL RTLS System CS3151 Tag CS5111LP Reader CS5113LP Reader with Ethernet Bridge 1
Table of Content User Manual of CSL RTLS System...............................................................................1 Introduction..................................................................................................................3 1 System Component Description..........................................................................4 1.1 CS3151.......................................................................................................4 1.1.1 Product Description ........
Introduction The CSL RTLS solution is based on the application of time of arrival technology. In the RTLS, an anchor is the device installed in a known position inside a zone, normally, at the corners of the zone. The moving tag inside the zone can measure the range to each anchor so as to obtain its absolute position inside the zone. A Zone Anchor Anchor Tag Anchor Anchor In a minimum system, 4 anchors – 3 normal anchors CS5111LP and 1 master anchor CS5113LP- are installed in a zone.
1 System Component Description 1.1 CS3151 1.1.1 Product Description CS3151 is a battery-operated active RFID tag. Three AAA size primary batteries ( either alkaline or lithium/Iron Disulfide )or Ni-MH rechargeable batteries can be installed for normal function. CS3151 are designed so that they can be attached to the tracking assets or simply hanging on the moving objects, depending on the applications.
1.1.3 Product Specification 1.1.4 Antenna Properties CS3151 employs embedded miniaturized Omni-directional chip antenna for effective RF transmission and reception. The antenna property is as below : Electrical Items Specifications Model 3030A5887-01 Type of antenna SMD chip type Frequency range 2400MHz – 2500MHz Nominal impedance 50 ohm Polarization Linear V.S.W.R 1.
Gain 2dBi typically, mounting on CS3151 Mechanical Items Specifications Dimension in millimeter 12.8(L) x 3.9(W) x 1.1(H) Weight 0.
1.2 CS5111LP 1.2.1 Product Description CS5111LP is the RTLS anchor( or reader). It integrates the high gain 2.4GHz ISM band antenna and the electronics PCB into one housing for robustness and easy installation. CS5111LP is designed to be mounted at the back panel. 1.2.2 Installation Procedure CS5111LP can be fed with DC voltage ranges from 12V to 38Vdc. The dc plug is 2.5mm locked type. CS5111LP is fully programmed and ready for normal operation once power is on.
1.3 CS5113LP 1.3.1 Product Description CS5113LP is the RTLS master anchor( or reader). It integrates the high gain 2.4GHz ISM band antenna and the electronics PCB into one housing for robustness and easy installation. CS5113LP has Ethernet connectivity function to communicate with the server application. CS5113LP is also a POE PD that can allow it to be powered through IEEE 802.3 certified PSE. 1.3.2 Installation procedure CS5113LP can be fed with DC voltage ranges from 12V to 36Vdc. The dc plug is 2.
1.3.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
