Installation Instructions

Limited Software Warranty, Liability, and Remedy

Important: This Control4 Software Limited Warranty shall cover

all software that is provided to you, the customer, as part of the

Control4 product, including any operation system software.

The Remedies provided in this document are your sole and

exclusive remedies. In no event shall Control4 be liable for any

direct, indirect, special, incidental, or consequential damages

(including lost profit), whether based on warranty, contract, tort,

or any other legal theory.

In no case shall Control4's liability exceed the purchase price for

the software and/or product. The limitations set forth above will

apply regardless of whether you accept the software.

Regulatory Compliance

This product complies with standards established by the

following regulatory bodies:

Federal Communications Commission (FCC)

Industry Canada

FCC

FCC ID: R33AVMTUN1X1

This device complies with Part 15 of the FCC Rules. Operation

is subject to the following two conditions: (1) This device may

not cause harmful interference, and (2) this device must accept

any interference received, including interference that may

cause undesired operation.

This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential

installation. This equipment generates uses and can radiate

radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful

PAGE 1
Limited Software Warranty, Liability, and Remedy Important: This Control4 Software Limited Warranty shall cover all software that is provided to you, the customer, as part of the Control4 product, including any operation system software. The Remedies provided in this document are your sole and exclusive remedies.
PAGE 2
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: ` Reorient or relocate the receiving antenna. ` Increase the separation between the equipment and receiver.