BON 11.1 14:4 14.2 18 Sosa 300 Religion A 2178} Table of Contents Introduction 3 Slope 3 Technical specifications 4 Description of the system 5 Receiver 4 Transmitter g Description of the Mesas 800 RXD receiver 6 Installation of the receiver, 7 Placement of the receiver 7 Connections on the receiver 8 indicators on the receiver 8 Configuration of the receiver 10 Basic configuration, 1G Advanced configuration 10 Erasing transmitters.
Installation of the-receiver B26) 6.2 Connections on the receiver The receiver is equipped with connections for relays, power and an eternal antenna (see fig. and fig. 2). Th Carryovers of: Powell connection. dre, [rom left to right: Ling 0 Neutral gy The connections for teach relay.
Configuration of the receiver 14.428) 8.3 Erasing transmitters in the receiver Erasing individual transmitters i. Bogon, The display shows SL 5» a followed by the memory position tat will be erased. This made will active foi {seconds 2. Change what memory position ch-deléte (110 S00) by using #9 and #7 buttons. The left:decimal in the display window indicates whether the: memory: position 15 in use or not (note that rive. decimals dre shown the display). 3.
Configuration of the receiver 12 (26 8.5 High Security Transmission Mode ‘the High Security Transmission. Mode uses encrypted authentication to ensure that the: receiver only replies [0 commands from transmitters stored in the man. airy. Phis rode makes diffidence Sean recording messages hat could, wit the right technology, open doors without-using an authentic coded transmitter Figs 4 Jumper Jt shown with high security transmission. mode enabled.
Configuration of the receiver 13(28) 8.6 Memory card Acquirement chard is useful in applications where many transmitters premised controlling single receiver.
Configuration of the receiver 26) 8.62 Copying information from a receiver ito a memory card Note that the memory card Hos to be jointly before copying the receiver memory northeastward: Fo remove information from memory: card; fuse rt the card dna DEW receiver and eras all antisemitism (See Chip 8.3% Lo Tum the power oll the receiver 2. Unscrew the 6 sores holding the receiver lid and remove the id: 3. Carefully more the display trad. 4.
Configuration of the transmitter 19426) 1.2 Display window Illumination The-display on the Mesas 1:99 has built in-automatic i illumination that ead be ON ar OFF. Typically, the battery {ife will increase by turning the illumination OFF, 11.2.4 Configuration of the display window illumination 1: Remove the back side the transmitter {see fig. 8 ¥ 2. Remove ong battery. 3. Press the bottom right bitten (on the: transmitter while destining the bag ery 4.
Installation of cassette 20426) 12. Installation of cassette Connect the cassette to 12724V DO where the brow cable is connected 16: dnd the blue cable to ground £4 tithe viable is congested wrong a fuse inside: eightieths will blow. This fuse cat bordered from Quakerisms Bighorn Ab wren 943696-000. To Shane the fuse: Lo Pantheistic bi instigating the screwworm the backside: 2. Lithe card up id bse of tweezers to remove the did fuse rand replace it with the new oni. 3.