Product Info

ManualsBrandsContrinex ManualsElectronicsInductive Identification (RFID) System

CONTRINEX AG Industrial Electronics

route du Pâqui 5 - P.O. Box - CH 1720 Corminboeuf - Switzerland - Tel: +41 26 460 46 46 -

Fax: +41 26 460 46 40 - Internet: www.contrinex.com - E-mail: info@contrinex.com

HF RFID SYSTEM

READ/WRITE MODULES (RWM)

HOUSING READ/WRITE DISTANCE

C44 ~80 mm*

GENERAL DATA INTERFACE

IO-Link SIO

Carrier frequency 13.56 MHz

Data transfer rate

230 400 baud

Compatible standard ISO 15693** LED green on

RWM power ON RWM power ON

Maximum transmission speed 26.5 kbit/s LED green blinking

IOL comm. on going

Read-write distance max.

~80 mm with RTP-0502-082 LED yellow on

Transponder detected See (Q1 / Q2) settings

LED yellow blinking

RSSI level ≤ RSSI threshold RSSI level ≤ RSSI threshold

LED red

Error was triggered Error was triggered

IO-Link

RLH-C44PA-NIS

ü 40x40 mm plastic housing

ü Sensing face of PBTP

ü Insensitive to dirt

ü IO-Link V1.1

ELECTRICAL DATA MECHANICAL DATA

Supply voltage range (Ub) 11...32 VDC Protection degree IP68 & IP69K

No-load supply current (field off) x mA Ambient temperature range TA*** -25...+80 °C

Max. current consumption (no load) x mA Storage temperature range TS**** -25...+80 °C

Short-circuit protection

Sensing face material PBTP

Voltage reversal protection

Housing material PBTP

Max. output current ≤ 200 mA Connector type M12 4-pin

Weight (incl. nuts) x g

* Please refer to table page 8

ü 2 x PNP output in SIO

mode configurable

** Protocol anti-collision excluded. A maximum of one transponder can be detected at a time by the RWM, otherwise "CollisionError" is reported

*** Read/write operations possible

**** Data retention and mechanical stability limit

Summary of content (8 pages)

PAGE 1
HF RFID SYSTEM READ/WRITE MODULES (RWM) RLH-C44PA-NIS HOUSING READ/WRITE DISTANCE C44 ~80 mm* ü 40x40 mm plastic housing ü Sensing face of PBTP ü Insensitive to dirt ü IO-Link V1.1 ü 2 x PNP output in SIO mode configurable * Please refer to table page 8 GENERAL DATA Carrier frequency Compatible standard Maximum transmission speed Read-write distance max. INTERFACE 13.56 MHz ISO 15693** 26.
PAGE 2
MOUNTING RECOMMENDATIONS CLEARANCE Read/write modules must not mutually influence each other. For this reason, a minimum distance of b between the devices must be observed. A : metal free zone B : sensing face C : support a : 80 mm b : x mm c : 90 mm d : 40 mm WIRING DIAGRAM PIN ASSIGNMENT L- 3 2 4 1 Ub 11...
PAGE 3
CONFIGURATION PARAMETER (IO-LINK / SIO MODE) Index Sub Hex Name Access Data Type Value Default SYSTEM 02h - Standard Command W uint8 5 = ParamDownloadStore, 128 = Device Reset, 130 = Restore Factory Settings, 160 = Locate device (force all leds to blink during 30 seconds) N/A 0Ch - Device Access Lock R/W uint16 Parameter Access, Data Storage, Local Parametrization and Local User Interface Locks 0000h 0Dh 0Eh 0Fh - Profile Characteristic PD Input Descriptor PD Output Descriptor R R R
PAGE 4
TAG INFO 43h 01h UID R uint64 Data available only if transponder is in the RWM detection range when TAG INFO fields are read - 02h Transponder DSFID R uint8 Data available only if transponder is in the RWM detection range when TAG INFO fields are read - 03h Transponder AFI R uint8 Data available only if transponder is in the RWM detection range when TAG INFO fields are read - 04h Number of Memory Blocks R uint8 Data available only if transponder is in the RWM detection range when TAG
PAGE 5
DEVICE DESCRIPTION 48h 01h Function Tag R/W char [] 02h Location Tag R/W char [] DEVICE CHARACTERISTIC 49h 01h RFID Compatibility R char [] “13.56 MHz, ISO15693” - 02h Read-write distance max R char [] “60 mm with diam 50mm SLIX tag” - 03h Supply voltage range (Ub) R char [] “11...32 VDC” - 04h Max.
PAGE 6
PROCESS DATA REPRESENTATION PROCESS DATA STRUCTURE - SCAN UID MODE PROCESS DATA INPUT Bitoffset Byte 7 6 0 1 2 3-10 11-18 19-26 27-31 RFU ERR 5 4 3 2 TAG ANT ERROR CODE RSSI UID 0 - UID 7 STTI 0 - STTI 7 TIRT 0 - TIRT 7 RFU 1 RFU ALR1 0 ALR2 Name Value Description 0 Command executed and no error ERR 1 Command executed but error 0 No tag present in front of the RWM TAG 1 Tag present in front of the RWM 0 RF field OFF ANT 1 RF field ON ERROR CODE See ERROR CODE list below 0 Alarm 1 OFF ALR1 1
PAGE 7
PROCESS DATA STRUCTURE - SCAN READ/WRITE MODE PROCESS DATA INPUT Bitoffset Byte 7 6 0 1 2 3-30 31 RDY ERR 5 4 3 2 TAG ANT RFU ERROR CODE ADDRESS DATA 0- DATA 27 RFU 1 0 RSSI ALR1 ALR2 Name RDY Value 0 → 1 Command executed and new data 1 → 0 available 0 1 0 Command executed and no error 1 Command executed but error 0 No tag present in front of the RWM TAG 1 Tag present in front of the RWM 0 RF field OFF ANT 1 RF field ON RSSI RSSI signal level coming from the transponder ERROR CODE See ERR
PAGE 8
POSSIBLE COMBINATION AND TYPICAL DISTANCE - RLH-C44PA-NIS Transponder type Ø9 Ø 16 Ø 20 Ø 20 Ø 26 Ø 30 Ø 30 Ø 50 Ø 50 Ø 50 Ø 50 Ø 50 RTP-0090-020 RTP-0160-020 RTH-D20QA-NC0 RTH-D20QA-ND0 RTP-0263-020 RTH-D30QA-NC0 RTH-D30QA-ND0 RTH-D50QA-NC0 RTH-D50QA-ND0 RTP-0502-022 RTP-0502-062 RTP-0502-082 Smax [mm] S0 [mm] D0 [mm] ~80 ~40 ~80 Working area Read/Write Module Transponder x POWER Model: RLS-C44PA-NxS OUTPUT Made by Contrinex D0 y S0 Smax AVAILABLE TYPES Part number Part reference Sensin