500 Install. Instruc. 7/1/03 8:24 PM Page 1 Model 500 Illustrated Installation Instructions Shower Doors DESIGNERS • MANUFACTURERS 26121 Avenue Hall • Valencia, CA 91355 (661) 257-1177 • Fax (661) 257-4907 Or visit our website at: www.cwdoor.
500 Install. Instruc. 7/1/03 8:24 PM Page 2 Illustrated Parts Breakdown (IPB) Drawing Model #500 14 12 4 11 1 10 10 14 12 11 9 10 4 11 11 4 3 12 15 8 10 12 4 4 3 12 9 8 15 6 7 4 13 12 5 2 NO. QTY #1 1 #2 1 #3 2 #4 6 #5 1 #6 1 #7 1 PART # A5010 A5020 A5060 S82075 G1150 NO.
500 Install. Instruc. 7/1/03 8:24 PM Page 3 In this instruction booklet we will walk you through the installation of your new shower door. DO NOT REMOVE your old shower door until you check your new shower door kit is the right size for your shower and that all the proper parts are in the box or hardware bag. NOTE: The Header (#1) and Bottom Track/Curb (#2) are shipped 1″ oversize, so you will need to cut each to fit.
500 Install. Instruc. 7/1/03 8:24 PM Page 4 NOTE: If your shower has curved corners, you may have to shape the Wall Jambs to fit snugly with the Bottom Track/Curb (#2). A Centerline Center Bottom Track/Curb on sill and mark position with pencil Figure 2 C. STEP 4 B. Drilling and Aligning the Wall Jambs Locate the Wall Jambs (#3). Looking at a Wall Jamb (#3) you will notice that the Jamb (#3) has two side legs, one which is narrower than the other. This narrow leg will face into the shower.
00 Install. Instruc. 7/1/03 STEP 6 A. B. C. D. 8:24 PM Page 5 Installing Wall Jambs and Bumpers framed Panels facing out, or to the front. The smooth surface of the glass will face into the shower. This orientation gives you the front and back of each panel. Now, select one of these panels to be the Outside Door Panel (#5) and one to be the Inside Door Panel (#6).
500 Install. Instruc. B. 7/1/03 8:24 PM Page 6 STEP 11 Gently lower the Rollers (#10) into position so that they are seated in the track. Make sure that the panel rolls freely. Inside Shower A. A B C. D. E. Hold the Outside Door Panel (#5) so that the Rollers (#10) are facing towards you.
500 Install. Instruc. 7/1/03 STEP 13 8:24 PM Page 7 Cleaning and Removing the Door Panels The enclosure door panels are not designed to be removed once they are installed. However, inconvenient areas that you may want to clean, such as the overlap between the doors, can still be reached for cleaning. A. Clean the glass and Bottom Track/Curb (#2) with a mild, non-abrasive cleaner. CAUTION: Removing one or both of the panels should NOT be attempted without assistance.