User Manual for TOKEN/TOKEN PLUS Fob Document : Project : MQ4 Fob 3B/4B/4Ba/6B Model name : SVI-MQ4aMFGE04 Version: 1.0 Date: Jul. 22. '22 Engineering change order-No.: Design Freeze No.: Number of pages: 6 Filename: Identification No.
Contents list 1. 1.1 1.2 1.2.1 1.2.2 1.2.3 1.3 2 3 Page System configulation Scope of SMART KEY SYSTEM Short description of the SYSTEM General Definition of SMART KEY Wireless Communication Concept Description System Overview / Block Diagram Smart Key Fob button operation FCC/IC Compliance Statement Editor : KS.Kim Version: 1.0 3 3 3 3 3 3 4 5 6 Document name Project code ECO / DF No. File: Jul. 22. 2022 Identification No. : Document No.
1. System configulation 1.1 Scope of SMART KEY SYSTEM The System offers the following features: passive access for two doors, driver side and passenger side as well as trunk/tailgate passive start after interior detection of the SMART KEY FOB (without interior trunk and hat shelf detection) LF-RF communication passive access trunk/tailgate via the trunk lid switch at the trunk max.
with a frequency of 125 kHz and ASK modulation is used. Inductive antennas in and at the vehicle radiate the electromagnetic energy. Technical aspects of 125 kHz – magnetic field: virtually no reflections, cubical decrease of field strength allows good range control, released frequency band (ISM), high penetration, low quiescent current demand due to 125 kHz input stage (SMART KEY FOB), less sensitive for detuning compared to higher frequency.
2 Smart Key Fob button operation Lock Hold (Trunk) Unlock Panic You can lock, unlock, trunk and hold your vehicle with this remote transmitter. Lock - When you push this button, all the doors will be locked. You can not lock any of the doors with this remote transmitter if any door is open or the key is in the fob holder. Unlock - When you push this button, all the doors will be unlocked.
3 FCC/IC Compliance Statement FCC Compliance Statement. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions : (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interferencethat may cause undesired operation. Do Not Any changes or modifications to the equipment not expressly approved by the party responsible for compliance could void user’s authority to operate the equipment.