Interior Car roof top Antenna with integrated Bluetooth transceiver DDA02 / DDAECE02 AUDI Part Numbers: 4N0 035 503 AP, 4N0 035 503 AR, 4N0 035 503 AQ, 4N0 035 503 AS (With different color codes for each number.
Interior Continental Part Numbers: 52512490, 52520087, 52512808, 52520088, 52520089, 52520090, 52520091, 52520092, 52520093, 52520094, 52520095, 52520096 52520097, 52520098, 52520100, 52520101, 52520102, 52520103, 52520104, 52520105, 52520107, 52520108, 52520109, 52520110, 52520111, 52520150, 52520151, 52520152, 52520159, 52520219, 52520220, 52520221, 52520222, 52520223, 52520224, 52520225, 52520283, 52520284, 52520285, 52520286, 52520287, 52520288, 52520304, 52520305, 52512495, 52512491, 52520112, 5252011
Interior 52520155, 52520160, 52520226, 52520227, 52520228, 52520229, 52520230, 52520231, 52520232, 52520289, 52520290, 52520291, 52520292, 52520293, 52520294, 52520306, 52520307, 52512496 (list may be enlarged depending on color code)
Interior Contents 1. Introduction .......................................................................................................................................... 5 2. Installation Options ............................................................................................................................... 6 3. Specification .......................................................................................................................................... 7 3.1.
Interior 1. Introduction The DDA is an automotive roof top antenna module with integrated Bluetooth transceiver for special usage. The Bluetooth circuit and electronics is designed to tunnel a not public described data stream via Bluetooth generic protocol. The device rejects any communication requests from Bluetooth devices not supporting the nonpublic payload format. The device is fully integrated to the electronics of the car.
Interior 2. Installation Options Example for a principle setup in a car. The DDA is designed for in-car use only. It is designed according the detailed specification of the OEM (car-manufacturer). It MUST be well integrated into the automotive environment (Tambient max. 95 °C) and needs to be installed by the OEM or in case of replacement by a professional garage.
Interior 3. Specification 3.1. General Specification Model Number DDA02 / DDAECE02 Antenna/Cradle Connectors FAKRA (male) DIN 72594-1/ISO 20860-1 DC Connector MQS-Type Impedance 50 Ohm Power Requirements Digital part :DC 6 V - 17 V; 100 mA SDARS: 5V ±10 %; 150 mA phantom feed GNSS: 5V ±10 %; 30 mA phantom feed Phone/ISM: no DC feed 3.2.
Interior 3.4. Navigation Radiator satellite pointing omnidirectional Frequency [MHz] Service Supported 1559,052 – 1605,375 GNSS Band L1 Supported Bands Max Gain of LNA 33 dB 3.5. Satellite Radio Radiator satellite pointing omnidirectional Frequency [MHz] Service Supported 2320 – 2345 SDARS Band S band Supported Bands Max Gain of LNA 31 dB 3.6. Bluetooth LE 4.
Interior 5. Safety and Recommendations WARNING: The DDA unit is designed for in-car use only. It MUST be well integrated into the automotive environment (Tambient max. 95 °C) and needs to be installed by the OEM (car-manufacturer) or in case of replacement by a professional garage. AVERTISSEMENT: L'unité DDA est conçue pour une utilisation dans une voiture uniquement. Il DOIT être bien intégré dans l'environnement automobile (Tambient max.
Interior WARNING: The Device must be installed no higher than 10 meters above ground. L'appareil ne doit pas être installé à plus de 10 mètres du sol. AVERTISSEMENT: Changes or modifications not expressly approved by Continental Advanced Antenna GmbH could void the authority to operate this equipment.
Interior 6. Legal Radiofrequency radiation exposure Information: This equipment complies with FCC and ISED radiation exposure limits set forth for an uncontrolled environment. NOTICE: This device complies with Part 15 of the FCC Rules and contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS standard(s). Operation is subject to the following two conditions: 1. this device may not cause harmful interference, and 2.
