Instructions / Assembly

ManualsBrandsConstruction Metals ManualsBuilding materials3 in. x 1 in. x 10 ft. Galvanized Steel Drip Edge Roof Starter Flashing

ROOF STARTER FLASHING

INSTALLATION GUIDELINES

These installation guidelines are for use with typical or standard applications. It is always recommended to seek advice from a licensed professional, and to

check with your local building inspector or building permit office for approvals and possible variations that may apply.

CAUTION!

Working above grade is inherently dangerous, be sure that proper fall protection measures are in place.

When working with power tools and sheet metal, gloves and eye protection are absolutely required.

1/32"

Over Driven

Begin installation along the eaves, starting at a corner and working your

way around. Hold the flashing tight against the fascia. Overlap each

succeeding piece of roof starter flashing by 2-3 inches.

After the roof starter flashing has been installed, apply the underlayment

and/or ice-water barrier.

Depending on local building codes and wind conditions, roof starter flashing

is typically nailed every 16".

½ in.

MINIMUM

½ in.

MINIMUM

Summary of content (1 pages)

PAGE 1
INSTALLATION GUIDELINES ROOF STARTER FLASHING ½ in. MINIMUM ½ in. MINIMUM Begin installation along the eaves, starting at a corner and working your way around. Hold the flashing tight against the fascia. Overlap each succeeding piece of roof starter flashing by 2-3 inches. Over Driven 1/32" After the roof starter flashing has been installed, apply the underlayment and/or ice-water barrier. Depending on local building codes and wind conditions, roof starter flashing is typically nailed every 16".