INSTRUCTION MANUAL CON1001 Recessed Entertainment Box 1
Congratulations on the purchase of your new Construct Pro Recessed Entertainment Box. We appreciate you, our valued customer, and are proud to announce our commitment to providing you with simple solutions for every installation. The CON1001 is an excellent source for nearly every installation project. It is uniquely designed to give you highest level of performance possible. Construct Pro offers a wide range of high performance products and quality solutions.
INSTALLATION INSTRUCTIONS STEP 1: TURN OFF POWER Switch power off at circuit breaker or fuse. Test that power is off before you begin any work with wiring. WARNING: FAILURE TO CUT POWER BEFORE WORKING WITH ELECTRICAL COMPONENTS MAY RESULT IN A FIRE OR CAUSE INJURY, SHOCK, OR DEATH. OFF ON OFF ON OFF ON OFF ON OFF ON OFF ON OFF ON OFF ON OFF ON OFF ON OFF ON OFF ON STEP 2.1: MOUNTING - New Construction Stud Mounted Installation (refer to Fig. A and Fig B): 1.
STEP 2.2: MOUNTING - Retrofit Construction Wall Mounted Installation (refer to Fig. C and Fig D): 1. Choose the optimal location. NOTE: 11” minimum clearance required to mount the CON1001 Entertainment Box between studs. Use a stud finder to determine and mark stud location behind surface of wall. Refer to Fig. C. 2. Use the front of the CON1001 Entertainment Box as a template to trace the cut-out area on the wall. Refer to Fig. C. Use a wallboard saw to cut-out the surface of the wall in that area.
STEP 3.1: WIRING APPLICATION Line Voltage Connections (refer to Fig. E): 1. Use a standard Single-Gang Device Box. 2. Insert the device box into the desire position on the CON1001 Entertainment Box. Attach from the inside. 3. Route the electrical wires to the device box. Be sure to choose an adequete line voltage device trhat is suitable for the desired application. NOTE: For complete wiring instructions consult the installation guide specific to the individual device. 4.
STEP 3.2: WIRING APPLICATION Low Voltage Connections (refer to Fig. F): 1. Use a standard Single-Gang Low-Voltage Bracket for low-voltage devices. 2. Insert the Low-Voltage Bracket into the desire position on the CON1001 Entertainment Box. Use the mounting screws on the Low-Voltage Bracket to attach it to the enclosure. 3. Route the low-voltage cables/wires through the bracket. Be sure to choose an adequete low-voltage device trhat is suitable for the desired application.
STEP 3.3: WIRING APPLICATION Component-to-Component Connections (refer to Fig. F and Fig. G): 1. Route low-voltage connections from component-to-component by using the included Quick-Snap cover plate. 2. Simply cut the pre-defined knock-out area off the Quick-Snap cover plate with a utility knife. Refer to Fig. G. NOTE: The pre-defined knock-out size is 1.25” in diameter. 3. Carefully pull low-voltage wires though the hole in the Quick-Snap cover plate.
TROUBLESHOOTING For technical assistance, contact your authorized Construct Pro dealer or Construct Pro customer service at 800.844.9555. CONSTRUCT PRO 9390 Veterans Memorial Parkway O’Fallon, MO 63366 Tech Support: 800.844.9555 email: retailsupport@skywalker.com www.skywalker.com ©2010 CONSTRUCT PRO. All Rights Reserved.