Preliminary User manual Intersil ISL37704C Indigo IEEE802.11a 5 GHz WLAN Cardbus Card User Manual Version 0.
Preliminary User manual Table of Contents 0-INTRODUCTION.................................................................................................... 3 1-CARD INSTALLATION PROCEDURE .............................................................. 3 1.1 INSTALLING THE CARDBUS CARD INTO THE HOST PC NOTEBOOK ................... 3 1.2 INSTALLING THE SOFTWARE DRIVERS................................................................ 3 1.3 WIRELESS LAN INSTALLATION GUIDE LINES AND AUTHORIZATION FOR USE . 7 1.
Preliminary User manual 0-Introduction The Intersil ISL37704C WLAN Cardbus Card is a complete wireless high speed Network Interface Card (NIC) utilizing the Intersil PRISM® 5 chip set. It provides a complete PRISM 5 reference design evaluation platform of hardware and software to system providers or integrators requiring wireless data communications capability and is ideal for integration into computer platforms. It supports the IEEE 802.
Preliminary User manual e-double click the Intersil WLAN icon to open the WLAN settings, the following window will appear (see fig.02) fig, 02: Intersil WLAN settings window f-click on configuration tab and select which type of network is required (access point or Peer-to-peer mode), see fig. 03.
Preliminary User manual g-select what TX rate is required (default setting is fully automatic) see fig. 04. fig, 04: WLAN tx rate setting window h-select what encryption type is required, 64 or 128 bit WEP (default setting is disabled) see fig. 05.
Preliminary User manual i-click on the status tab to see the connection status (fig.06). fig, 06: WLAN network status j-click on the about tab to see the software drivers versions and MAC address (fig.07).
Preliminary User manual 1.3 Wireless LAN installation guide lines and Authorization for use Installation and use of this Wireless LAN device must be in strict accordance with the instructions included in the user documentation provided with the product. Any changes or modifications made to this device that are not expressly approved by Intersil may void the user’s authority to operate the equipment.
Preliminary User manual 2-Regulatory information 2.1 FCC Information to User This product does not contain any user serviceable components and is to be used with approved antennas only. Any product changes or modifications will invalidate all applicable regulatory certifications and approvals 2.2 Product Compliance This Indigo device complies with the standards as shown in table below: country USA European Union Japan Approval specification FCC part 15, sections 15.107, 15.109, 15.207, 15.209, 15.
Preliminary User manual 2.5 Export restrictions: This product or software contains encryption code which may not be exported or transferred from the US or Canada without an approved US Department of Commerce export license. 2.6 FCC Guidelines for Human Exposure SAR (Specific Absorption Rate) for this device was measured in accordance with FCC OET Bulletin 65 (Supplement C) and guidelines established in IEEE C95.1-1991.
Preliminary User manual 3-Technical Specifications Radio Technology Operating Frequency Modulation Schemes Data Rate Media Access Protocol Transmitter RF Output Power Antenna Type Operating Voltage Interface Device driver Support FCC ID: OSZ37704C IEEE 802.11a (OFDM) 5150MHz – 5350 MHz DQPSK, DBPSK, CCK, 16 QAM, 64 QAM Support for 54, 48, 36, 24, 18, 12, 9, and 6 Mbps data rates CSMA/CA with ACK < 18.0 dBm EIRP (typical) including antenna gain PCB integrated antennas with 1 dBi rated gain 3.