User Manual

USER Manual

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates uses and can

radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the interference by one of

the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

FCC Caution

: Any changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate this equipment.

INDUSTRY CANADA STATEMENTS

Operation is subject to the following two conditions: (1) this device may not cause interference,

and (2) this device must accept any interference, including interference that may cause

undesired operation of the device.

To reduce potential radio interference to other users, the antenna type and its gain should be so

chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that permitted

for successful communication.

This device has been designed to operate with the Johanson Technology ceramic chip

antenna, part number 2450AT43B100, and having a maximum gain of +1.3 dB. Antennas not

included in this list or having a gain greater than +1.3 dB are strictly prohibited for use with this

device. The required antenna impedance is 50 ohms.

PAGE 1
USER Manual Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
PAGE 2
Responsibilities to comply with FCC and Industry Canada Regulations The 2.4GHz Module has been certified for integration into products only controlled by Computer Security Systems, Inc d.b.a. Saflok under the following conditions: 1. The transmitter module must not be co-located or operating in conjunction with any other antenna or transmitter. 2. The antenna approved for this device is the Johanson Technology ceramic chip antenna, part number 2450AT43B100.