User's Manual

Information sheet for Model 4100 Radio Sensor. To be printed on the flaps of the
box containing the sensor at top assembly package.
***********************************************************************
This device is a component of the Status Technologies Wireless Sensor System. It
must be used with appropriate Model 4200/4210 Transceivers (FCC ID:
NL54200/NL54210) and an appropriate accessory support package. The instructions
for installation and operation of this device are contained with in a manual
supplied as a component of the accessory support package.
WARNING: The 4100 RF Sensor is powered by lithium batteries.
Lithium batteries are a fire, explosion, and severe burn hazard. Do not
recharge, diassemble, heat above 100 degrees C. , incinerate, or expose contents
to water.
NOTICE: The batteries should be promptly removed from the unit when the end of
their life is reached. The exhausted batteries must be disposed of in an
acceptable manner.
NOTE: This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct
the interference at his own expense.
Operation of this device is subject to the two following conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired
operation.
This device was tested and approved in the design and configuration which is
supplied in this package. It must be installed and used in the manner described
in the user manual supplied with the accessory package. The design must not be
modified in any way. Such modifications could void the users authority to
operate the equipment.