CE-HD330RS HDMI/IR/RS-232 over Single CAT5e/CAT6 Extender Operation Manual
DISCLAIMERS The information in this manual has been carefully checked and is believed to be accurate. Cypress Technology assumes no responsibility for any infringements of patents or other rights of third parties which may result from its use. Cypress Technology assumes no responsibility for any inaccuracies that may be contained in this document. Cypress also makes no commitment to update or to keep current the information contained in this document.
SAFETY PRECAUTIONS Please read all instructions before attempting to unpack, install or operate this equipment and before connecting the power supply. Please keep the following in mind as you unpack and install this equipment: • • electrical shock and injury to persons. moisture or install this product near water. • Never spill liquid of any kind on or into this product.
CONTENTS 1. Introduction ............................................ 1 2. Applications ........................................... 1 3. Package Contents ................................ 1 4. System Requirements ............................ 1 5. Features .................................................. 2 6. Operation Controls and Functions ....... 3 6.1 Transmitter Front and Rear Panels ..3 6.2 Receiver Front and Rear Panels .....4 .....................5 6.4 IR Cable Pin Assignment..................5 7.
1. INTRODUCTION The HDMI with RS-232 over Single CAT5e/CAT6 transmitter and receiver set can send uncompressed audio/video over a single run of CAT5e/6 built-in RS-232 and IR ports. *Light version can run up to 60m 2. APPLICATIONS • Household entertainment sharing and control • Lecture room display and control • Showroom display and control • Meeting room presentation and control • Classroom display and control 3.
5. FEATURES • HDMI including 3D, 4k×2k supports, HDCP and DVI compliant • Supports HDCP repeater and CEC function • Simultaneous transmission of uncompressed data over a single CAT6/CAT5e cable up to 100 m/328 ft* • Uncompressed video 1080p, 60 Hz, 36-bit • Audio support up to LPCM 7.1CH, Dolby TrueHD and DTS-HD Master Audio • 3Play convergence: HDMI & Control (IR & RS-232) • Installation friendly Note: This system was tested with CAT6/23AWG cable. Results may *Light version CAT6/CAT5e cable up to 60m/196.
6. OPERATION CONTROLS AND FUNCTIONS 6.1 Transmitter Front and Rear Panels Front IR2 Extender RS232 In 1 Rear HDMI In DC 5V Power Link IR1 Blaster 2 3 CAT 5e /6 Out 4 5 6 7 8 1 RS-232 In: Connect to a PC/laptop or RS-232 enabled device(with supplied 3.5 mm phone jack to D-Sub 9 pin adaptor) for the transmission of RS-232 commands. 2 IR2 Extender: Connect to the supplied IR extender cable for IR signal reception.
6.2 Receiver Front and Rear Panels Front IR1 Extender HDMI Out DC 5V Power Link IR2 Blaster RS232 Out 1 Rear 2 3 CAT 5e /6 In 4 5 6 7 8 1 RS-232 Out: Connect to the device that is to be controlled (with the supplied 3.5mm phone jack to D-Sub 9-pin adaptor) by RS-232 commands. 2 IR1 Extender: Connect to the supplied IR extender cable for IR signal reception. Ensure that remote being used is within the direct line-of-sight of the IR extender.
PIN DEFINE TX/RX 1 N/C 2 TxD/RxD 3 RxD/TxD 4 N/C 5 GND 6 N/C 7 N/C 8 N/C 9 N/C 6.
7. CONNECTION DIAGRAM DVD or Blu-ray Player RS-232 Adaptor HDMI 1.5m 60° 3m 7m m IR Blaster 3m 60° IR Extender Power Supply IR2 Extender RS232 In RS-232 Equipped PC or Notebook HDMI In TX IR1 Blaster DC 5V Power Link CAT 5e /6 Out Single CAT5e/6 Cable Power Supply DC 5V Power Link CAT 5e /6 In IR1 Extender RS232 Out HDMI Out RX IR2 Blaster IR Blaster 60° IR Extender 3m 7m m RS-232 Adaptor 1.
8. SPECIFICATIONS Video Bandwidth 225MHz/6.
9.