User's Manual

ManualsBrandsCompex Systems ManualsComputers & AccessoriesWIRELESS-G 23DBM NETWORK MINI PCI ADAPTER

This device is intended only for OEM integrators under the following conditions:

1) The antenna must be installed such that 20 cm is maintained between the

antenna and users. For laptop installations, the antenna must be installed to

ensure that the proper spacing is maintained in the event the users places the

device in their lap during use (i.e. positioning of antennas must be placed in the

upper portion of the LCD panel only to ensure 20 cm will be maintained if the user

places the device in their lap for use), and

2) The transmitter module may not be co-located with any other transmitter or

antenna. As long as the 2 conditions above are met, further transmitter test will not

be required. However, the OEM integrator is still responsible for testing their

end-product for any additional compliance requirements required with this module

installed (for example, digital device emissions, PC peripheral requirements, etc.).

IMPORTANT NOTE:

In the event that these conditions can not be met (for example certain laptop

configurations or co-location with another transmitter), then the FCC authorization

is no longer considered valid and the FCC ID can not be used on the final product.

In these circumstances, the OEM integrator will be responsible for re-evaluating

the end product (including the transmitter) and obtaining a separate FCC

authorization.

End Product Labeling:

This transmitter module is authorized only for use in device where the

antenna may be installed such that 20 cm may be maintained between the

antenna and users (for example access points, routers, wireless ADSL modems,

certain laptop configurations, and similar equipment). The final end product must

be labeled in a visible area with the following:

"Contains TX FCC ID: TK4-WLM54GP23".

Manual Information for End Users

The end user must not have manual instructions to remove or install the

device. The user manual for end users must include the following information in a

prominent location.

"IMPORTANT NOTE:

To comply with FCC RF exposure compliance requirements,

the antenna used for this transmitter must be installed to

provide a separation distance of at least 20 cm from all persons

and must not be co-located or operating in conjunction with

any other antenna or transmitter."

Summary of content (5 pages)

PAGE 1
This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna and users. For laptop installations, the antenna must be installed to ensure that the proper spacing is maintained in the event the users places the device in their lap during use (i.e.
PAGE 2
NETPASSAGE 1. Quick Install Guide Introduction Compex Wireless-AG Mini PCI Adapter WLM54GP23 Version 1.1 This mini PCI adapter, Compex WLM54GP23 contains a dual-mode single chip MAC/BB/Radio for IEEE 802.11a, 11g and 11b Wireless LAN. It can support high-speed data transmission of up to 54Mbps in the 2.4GHz and 5GHz frequency bands based on 802.11b/g and 802.11a mode respectively. Based on the latest industry standard Wi-Fi Certified IEEE 802.
PAGE 3
4. Access to Web-based Interface Now, your Compex WLM54GP23 acts as a DHCP Server which can assign IP address to your PC/clients. Compex has developed a powerful uConfig utility which provides you hassle-free access to the web-based configuration page. To do so, simply 6. WLAN Basic Setup for Compex WLM54GP23 1. Insert your Product CD into your CD-ROM drive. Go to Utilities section and select uConfig to run the program. 1. 2. The following screen shot will appear.
PAGE 4
. Select the radio buttons for Obtain an IP address automatically and Obtain DNS server address automatically. Click OK button to update the changes. Next, you may set up Windows XP’s Wireless Network Connection as follows: 5. 6. Right click on Wireless Network Connection corresponding to the Wireless Ethernet Adapter you wish to connect to your Compex WLM54GP23 and click on Properties. Go to Wireless Networks tab and click on Add.. button. 7.
PAGE 5
8. Panel Views and Descriptions Disclaimer: Compex, Inc. provides this guide without warranty of any kind, either expressed or implied, including but not limited to the implied warranties of merchantability and fitness for a particular purpose. Compex, Inc. may make improvements and/or changes to the product and/or specifications of the product described in this guide, without prior notice. Compex, Inc will not be liable for any technical inaccuracies or typographical errors found in this guide.