User's Manual

ManualsBrandsCompex Systems ManualsComputers & AccessoriesWIRELESS-A/B/G/N NETWORK MINI PCIe ADAPTER

WL84E

Wireless N Mini PCI-E Ada pter

Use r Manual

Ve r: 1.0

Table of Contents

CHAPTER 1

INTRODUCTION.......................................................................2

1.1

FEATURES................................................................................................2

1.2

ENVIRONMENTAL.......................................................................................2

1.3

PACKAGE.................................................................................................3

CHAPTER 2

INSTALLATION.........................................................................3

2.1

Hardware Installation......................................................................3

2.2 SOFTWARE

INSTALLATION..........................................................................3-8

Summary of content (9 pages)

PAGE 1
WL8 4 E Wire le ss N M ini PCI -E Ada pt e r U se r M a nua l V e r: 1 .0 Table of Contents CHAPTER 1 INTRODUCTION.......................................................................2 1.1 FEATURES................................................................................................2 1.2 ENVIRONMENTAL.......................................................................................2 1.3 PACKAGE.................................................................................................
PAGE 2
Chapter 1 Introduction The WL84E Wireless N Mini PCI-E Adapter complies with IEEE 802.11n (Draft 2.0), IEEE 802.11a, IEEE 802.11g, and IEEE 802.11b standards. Wireless transmission rates can reach up to 300Mbps. This product supports 64/128-bit WEP encryptions and DFS in requires 5-GH bands, as well as WPA/WPA2 and WPA-PSK/WPA2-PSK encryptions and mechanisms in addition to the adapter’s QSS (Quick Secure Setup) feature, allowing users to quickly and easily configure wireless security.
PAGE 3
• • • One WL84E WLAN Card WL84E Manual WL84E Drives and Manual on CD-ROM Chapter 2 Installation 2.1 Hardware Installation To install the adapter, follow these steps listed below: 1. Turn off your desktop PC and disconnect the power. 2. Remove your PC case and locate an available PCI slot on the mianboard. Remove the metal slot cover on the back of the PC. Check with your computer manufacturer for instructions if needed. 3. Slide the PCI Adapter into the PCI slot.
PAGE 4
2. Soon, Figure 2-2 will display after a moment. Click Next to continue. 3. After that, you should choose a Setup type. It is recommended that you select Install Client Utilities and Driver. Select Install Driver Only to install driver only, and select Make Driver Installation Diskette(s) to make the diskette(s) as the installation driver (shown in Figure 2-3). Click Next to continue.
PAGE 5
4. Click Browse to change the destination location for the software, then click Next in the screen below (shown in Figure 2-4). 5. After that, select the program folder, you should create a new folder name or select one from the Existing Folders list. It is recommended that you keep the default setting. Click Next to continue the installation.
PAGE 6
. Choose configuration tool, if you are not sure, please leave it default. Then click Next to continue. 7. Click OK to continue the Installation on the screen below.
PAGE 7
8. Wait a while for the setup as shown in Figure 2-8. Note: For Windows XP, the Setup Wizard will notify you of how to proceed with the installation during these steps (shown in Figure 2-9). Our drivers have been tested thoroughly, and are able to work with the operating system. Click Continue Anyway to continue the Installation.
PAGE 8
9. After all the steps above, you will see the screen below, click Finish to complete the installation.
PAGE 9
FCC WARNING This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE 1: Any changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment.