B&C Iot module user manual Revision: v.1 Date: 02.02.2022 Issued By: Eva Raigo FCC ID: 2AQHSF0010262 IC ID : 25027-F0010262 Reviewed By: The content of this document is confidential and intended for the recipient specified in message only. It is strictly forbidden to share any part of this message with any third party, without a written consent of the sender.
Table of contents Table of contents Amendments 1 2 Introduction Product Bonnie & Clyde overview 3 3 Installation Description of installation process of Bonnie & Clyde product 4 4 Required equipment 4 Bonnie & Clyde part description 4 Bonnie & Clyde installation 5 Interference 6 1
Amendments Revision Implementation date Release notes v1.0 02.02.2022 First issue. v1.1 12.07.
Introduction Product Bonnie & Clyde overview The COMODULE IoT device is designed to be connected wirelessly into existing network infrastructure to gather and transmit data and to be controlled remotely. It thus creates opportunities for the physical world to be digitalized, which results in improved efficiency, accuracy and economic benefits. This manual is intended for electric bike manufacturers for COMODULE IoT module integration.
Installation Description of installation process of Bonnie & Clyde product Required equipment ● ● ● Bonnie & Clyde product Mounting adapters for fixing the Bonnie part inside the bike frame Mounting adapters for fixing the Clyde part inside the bike motor cover General description of the Comodule product and the vehicle into which integration is done. Possibly a quick overview of the general concept (Sharing or OEM etc) and the scope.
Bonnie & Clyde installation ! This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body. To satisfy RF exposure requirements, this device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.
Interference INSTRUCTION TO THE USER: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.