USER MANUAL IOT MODULE NB S Sharing 2.3 FCC ID: 2AQHSF0010005 www.comodule.
Introduction The COMODULE IoT device is designed to be connected wirelessly into existing network infrastructure to gather and transmit data and to be controlled remotely. It thus creates opportunities for the physical world to be digitalized, which results in improved efficiency, accuracy and economic benefits. This manual is intended for electric kick scooter service providers for COMODULE IoT module integration. www.comodule.
Installation For the installation, the following equipment is needed: COMODULE IoT module Sharing 2.3 Fixation plate Bolts for installation (come with COMODULE device) Compatible electric kick scooter Installing the modules on the scooters 1. Plug the scooters to the electricity and make sure they show battery signal on the display. 2. Attach the IoT module to the scooter. Use bolts and fixation plate to fasten the module. 3. Plug the cable of the module to the cable of the scooter. www.
Interference INSTRUCTION TO THE USER: INSTRUCTION TO THE USER: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. In order to maintain compliance with FCC regulations, shielded cables must be used with this equipment. Operation with non‐approved equipment or unshielded cables is likely to result in interference to radio and TV reception.
