Installation Manual

ManualsBrandsComnet ManualsAccessoriesPoE Setup Tool

INS_CLSETUP_REV–

12/18/11

PAGE 1

INSTALLATION AND OPERATION MANUAL

CLSETUP

IP CAMERA SETUP AND POE TESTER

The ComNet

™

CopperLine CLSETUP provides a simple way to setup and focus PoE-

powered IP cameras, and is an ideal diagnostic tool for installers working with both

CCTV and IT PoE-based systems. The CLSETUP is compatible with IEEE 802.3af and

IEEE 802.3at PoE standards up to 30W.

See Figures 1 – 3 for complete installation details.

Important Safety Warning:

Read and keep these directions

Heed all warnings

Follow all instructions

Do not use this apparatus near water

Clean only with a dry cloth

Install in accordance with the manufacturer’s

instructions

This installation should be made by a qualiﬁed

service person and should conform to all local codes

See further safety instructions on Page 3

Summary of content (3 pages)

PAGE 1
INSTALLATION AND OPERATION MANUAL CLSETUP IP Camera Setup and POE Tester Important Safety Warning: Read and keep these directions Heed all warnings Follow all instructions Do not use this apparatus near water Clean only with a dry cloth The ComNet™ CopperLine CLSETUP provides a simple way to setup and focus PoEpowered IP cameras, and is an ideal diagnostic tool for installers working with both CCTV and IT PoE-based systems. The CLSETUP is compatible with IEEE 802.3af and IEEE 802.
PAGE 2
INSTALLATION AND OPERATION MANUAL CLSETUP FIGURE 1 – CLSETUP CAT5 FIGURE 2 – CCLSETUP LEFT PANEL RIGHT PANEL Directions for the CLSETUP IP Camera Setup and POE Tester Refer to Figure 3 • Disconnect the network cable • Connect pigtail cable to the camera • Connect network cable to “Network” connector • Connect “Laptop” connector to your laptop using standard patch cable • After the camera power is on the CLSETUP will display the PoE voltage applied to the camera • Open your browser or viewing softwa
PAGE 3
MECHANICAL INSTALLATION INSTRUCTIONS • Read and keep these directions. • Heed all warnings. • Follow all instructions. • Do not use this apparatus near water. • Clean only with a dry cloth. • To reduce the risk of fire or electrical shock, do not expose these products to rain, moisture, dripping or splashing. • No objects filled with liquids, such as vases, shall be placed on the equipment. • DO NOT install the unit in a place where the operating ambient temperature exceeds 75ºC.