Data Sheet

LIFETIME WARRANTY WWW.COMNET.NET TECH SUPPORT: 1.888.678.9427

CL-SFP

Small Form-Factor Pluggable

Copper Range Extender Module

FEATURES

› Extends Ethernet up to 3,000 feet (914 m) at 10 Mbps or

1,000 feet (305 m) at 100 Mbps over 1 pair UTP cable.

› Extends Ethernet up to 5,000 feet (1,524 m) at 10 Mbps or

2,000 feet (610 m) at 100 Mbps over Coaxial cable using the

optional CLRJ2COAX or CLRJ2COAXCAB adapters.

› Automatic local/remote device selection ensures ultimate

flexibility and ease of use.

› Small Form-Factor Pluggable (SFP) module can be

plugged into any Ethernet switch with SFP ports that

support 100BASE-FX*

› Tested and certified by an independent laboratory for full

compliance with the environmental requirements (ambient

operating temperature, mechanical shock, vibration, humidity

with condensation, high-line/low-line voltage conditions

and transient voltage protection) of NEMA TS-1/TS-2 and

CALTRANS Traffic Signal Control Equipment Specifications

› Lifetime Warranty

The ComNet

™

CopperLine® CL-SFP is a small form-factor pluggable Ethernet extender

module that improves bandwidth and distance of existing copper networks. It helps

avoid installation costs of new fiber lines on site by allowing full 10 Mbps or 100 Mbps

Ethernet bandwidth to be extended over 2-wire twisted pair or coaxial cable.

Housed in a small form-factor pluggable (SFP) module enclosure, it is designed for

plug-and-play installation into any 100BASE-FX Ethernet unit with an MSA-compliant

port. These must be used in pairs, with a CL-SFP module installed at both ends of the

connection, or a CopperLine unit installed at one end.

APPLICATIONS

› Retrofit existing analog CCTV installations to

Ethernet-based systems

› CCTV systems for Casinos, airports, school campuses

EXTENDER

* The ComNet Copperline CL-SFP modules are fully compatible with

all ComNet Ethernet products supporting 100BASE-FX SFP modules.

The modules cannot be used in ports that only support 1000BASE-FX

SFP modules.

Please contact ComNet technical support before purchasing this

product if you intend to use it with any other 3rd party manufacturer

in order to check compatibility.

PAGE 1
Small Form-Factor Pluggable Copper Range Extender Module CL-SFP EXTENDER The ComNet™ CopperLine® CL-SFP is a small form-factor pluggable Ethernet extender module that improves bandwidth and distance of existing copper networks. It helps avoid installation costs of new fiber lines on site by allowing full 10 Mbps or 100 Mbps Ethernet bandwidth to be extended over 2-wire twisted pair or coaxial cable.
PAGE 2
Small Form-Factor Pluggable Copper Range Extender Module CL-SFP INSTALLATION & OPERATION SPECIFICATIONS CL-SFP is a book-end solution that can work only with an additional CL-SFP or ComNet™ CopperLine® unit. Interface Type 100BaseTX Connector SFP / MSA Compliant Connectors RJ-45 Data Rate 10 or 100 Mbps Follow the instructions below to install and connect CL-SFP: Plug one of the two CL-SFP into the 100BASE-FX SFP slot of a device/switch. Repeat this step for the second CL-SFP in the pair.