User's Manual Part 95

OWNER’S MANUAL
MODEL CSTXR.1
LPRS
TRACKING TRANSMITTER
INTRODUCTION
The Communications Specialists Model CSTXR.1 wrist or ankle mounted transmitter is
used as a homing device to locate persons under authority or agreement with a law
enforcement agency (federal, state, or local) having jurisdiction in the area where it is
placed. It is programmed at the factory to transmit on any one of 200 individual
narrowband channels in the Low Power Radio Service (LPRS). This allows 200
transmitters to be used simultaneously in an area for unprecedented flexibility. Power
output is 10 mW. It uses a widely available CR2450 Lithium battery which operates the
transmitter for more than 30 days. The CSTXR.1 utilizes a TCXO rather than a fragile
crystal so it is almost indestructible. The case is completely waterproof and the
transmitter module itself is also completely waterproof.
Photo #1
ASSEMBLY AND BATTERY INSTALLATION
1. Drop the transmitter module into the housing as shown
in photo #1.
2. Place the battery on top of the transmitter module as shown
in photo #2. The plus (+) side of the CR2450 battery is
facing up as shown. If the battery is accidentally reversed,
Photo #2
the transmitter will not operate but it will not be damaged.
Just pop out the battery and reverse it to resume operation.
3. Place the battery cap over the + side of the battery and use
the supplied tool to tighten it.

Summary of content (2 pages)