******** MB-50901 Tilting Wall Mount for Flat Panel TVs 200/300/400/600)
4-7 Before you begin, carefully read and understand the instructions in this manual. Please follow the instructions in the order presented in this manual and observe all warnings and cautions. three 100 lbs. (45.36kgs). 2.1''(53mm) 16.7''(425mm) 3.9''(100mm) 3/16 in. (4.5mm) min3.9~max15.7''(min100~max400mm) 25.3''(643mm) min3.9~max23.6''(min100~max600mm) This mount has been tested to support a television with diagonal screen sizes between 37in. and 90in. (94 cm & 2.
Pre-Installation masonry Lag bolt washer (sizes M6x30, M8x30, M8x50) Mounting plate Left mounting bracket Right mounting bracket 1 10 20 2 30 40 50 3 60 70 4in 80 90 100mm
DD EE FF Screw fits correctly Screw is too long Screw is too short CAUTION: To avoid potential personal injuries and property damage, make sure that there are adequate threads to secure the brackets to your TV. If you encounter resistance, stop immediately and contact customer service. Use the shortest screw and spacer combination to accommodate your TV. Using hardware that is too long may damage your TV. However, using a screw that is too short may cause your TV to fall from the mount.
Installation (continued) 3 Attaching the mounting brackets to the TV Attach the mounting brackets (B, C) to the back of the TV using the screws (DD), washers (EE) and spacers(FF) you identified in step 1. Note: If you use a Samsung TV with deeper VESA holes, please use M8x50 screws and Samsung spacers. ( These spacers are included with Samsung TV. ) CAUTION: Tighten the screws so the brackets are firmly attached. DO NOT OVERTIGHTEN. This may damage your TV.
Installation (continued) Installing the mounting plate (concrete/masonry wall) 6 masonry blocks masonry block. Use the mounting plate (A) as a template to mark the installation holes. Use a level to ensure the plate is level. Use a 1/4 in. (6 mm) masonry drill bit to slowly drill 2.4 in. (60mm) pilot holes.Then use a 3/8 in. (10 mm) masonry drill bit to expand pilot holes. Insert anchors (AA) into the holes.
Installation (continued) 6 Installing the mounting plate (wood stud) Use a commercially-available stud finder to locate the stud centers in the wall. Studs are usually spaced 16 in. apart. Use the mounting plate (A) as a template to mark the installation holes. Use a level to ensure the plate is level. Use a 3/16 in. (4.5 mm) wood drill bit to drill 2.2 in. (55 mm) pilot holes.