OEM/Integrators Installation Manual EZ-HS301 Microwave Module FCC ID: CCEEZ-HS301
Introduction 1. Scope This module is intended tobe installed on COMMAX Co., Ltd.’s line of product. 2. General description Rating power of this module is DC 5V. It contains the MCU CONTROLLER and Outputs 5V only when it detecs object. The idle output is 0V. 3. Dimension 36mm x 20mm x 1.0T 4. Characteristic No such environmental conditions such as dust, temperature, light and noise will affect this module’s performance.
Specification 1. Environment Spec. Operating temperature: -20~60℃ Operating humidity: 0~80%RH 2. Electrical Spec. 1)Rating power: DC 5V 2)Range of power : DC 4.8 – 5.2 Vdc 3)Output power : DC 0 - 5V 3. Radar spec. ( could be differ by regional conditions ) 1) Distnace : approx. 1.5 ~ 2M 2) Angle : VERTICAL : approx. 50°, HORIZONTAL : approx.
Federal Communication Commission Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Federal Communication Commission Statement OEM Responsibilities to comply with FCC - The module is limited to OEM installation only. - The OEM integrator is responsible for ensuring that the end-user has no manual instructions to remove or install module. - The module is limited to installation in mobile or fixed applications. - The transmitter module must not be co-located or operating in conjunction with any other antenna or transmitter except in accordance with FCC multi-transmitter product procedures.