Installation Guide

RF-24DP-D Wireless Remote Control

For Cub series ATV/UTV Winch

Wireless Control Kit includes:

1 Wireless Receiver.881103

2 Wiring Harness 1250 mm.

3 Wireless Transmitter.883822

4 Lithium Battery: 3V CR2032

5.Handsaver Strap.

I.Specifications

1. Transmission range: 15 ~ 27 m (50 ~ 90 ft)

2. Receiver operation voltage: 8 ~ 24 V

3. Receiver fuse current rating: 7.5A

4. Protection: IP-66

5. Operating temperature range: -20°C ~ +70°C

6. LED indication: Green light for power on; Red light for winching; Blinking green for low battery

life; Blinking red light for poor signal received

II.Installation Guide

Step 1: Connect the wiring

a. Connect the Black and Green wires to the same color wires on the contactor and

handlebar trigger switch respectively shown on the wiring diagram.

b. Slice the Red wire to the receiver fuse then connect to the positive (+) terminal of the

battery.

c. Connect the Black wire to the negative (-) terminal of the battery.

Step 2: Mount the Receiver

a. The receiver should be mounted in a clear and dry location.

b. Mount on a flat surface with 2 pcs of Ø7 mm mounting

holes on each side of the receiver.

INSTALLATION GUIDE

Minimum of one mounting hole each side

Part No.883873

LED indication

PAGE 1
INSTALLATION GUIDE Part No.883873 RF-24DP-D Wireless Remote Control 1. 2. For Cub series ATV/UTV Winch Wireless Control Kit includes: 1 Wireless Receiver.881103 2 Wiring Harness 1250 mm. 3. 4. 5. 3 Wireless Transmitter.883822 4 Lithium Battery: 3V CR2032 5.Handsaver Strap. I.Specifications LED indication 1. Transmission range: 15 ~ 27 m (50 ~ 90 ft) 2. Receiver operation voltage: 8 ~ 24 V 3. Receiver fuse current rating: 7.5A 4. Protection: IP-66 5. Operating temperature range: -20°C ~ +70°C 6.
PAGE 2
III Operation Lithium Battery: CR2032 (3V) 1. Install and replace battery. a. Turn cover counterclockwise to open. b. Replace new battery and put the cover back. c. Turn cover clockwise to close. 2. Start a. Turn on the ATV/UTV. b. Press the Power button for 5 seconds until Green light comes on. c. Press the Cable In or Cable Out button , then the Red light comes on. Power Button LED Indicator Cable OUT Cable IN Cable IN Cable OUT 3. Stop a.