User's Manual

ManualsBrandsCogent Systems ManualsElectronicsRF-READER

Cogent systems

RF-READER USER MANUAL

- 1 -

RF-READER 安装及测试方法

RFREADER USER MANUAL

准备：读卡器、非接触卡（Desfire、Mifare）、驱动、Demo(CLR2007.exe)

Preparations: RF-READER, contact less card(Desfire、Mifare), driver, Demo(CLR2007.exe)

z 驱动安装：

Driver installation:

一、设备接入计算机，提示驱动安装，选择“否，暂时不”继续“下一步（N）”如下图：

Connect the RF-READER to PC. While the message box suggesting you to install the driver,

choose “N, temporarily” and then choose “next” as picture below:

（DRIVERINSTALL_1）

二、选择“从列表或指定位置安装（高级）”，选择“下一步（N）”，如下图：

Choose the item “select from list or specified path (senior).Then press “next (N)”. See the picture.

Summary of content (7 pages)

PAGE 1
Cogent systems RF-READER USER MANUAL RF-READER 安装及测试方法 RFREADER USER MANUAL 准备：读卡器、非接触卡（Desfire、Mifare）、驱动、Demo(CLR2007.exe) Preparations: RF-READER, contact less card(Desfire、Mifare), driver, Demo(CLR2007.exe) z 驱动安装： Driver installation: 一、设备接入计算机，提示驱动安装，选择“否，暂时不”继续“下一步（N）”如下图： Connect the RF-READER to PC.
PAGE 2
Cogent systems RF-READER USER MANUAL （DRIVERINSTALL_2）三、浏览到驱动文件所放文件夹，确定，选择“下一步（N）”如下图， Browse the driver’s documents, press “Y” and choose “next (N)” as the following picure: （DRIVERINSTALL_3）四、开始安装驱动程序，如下图： Start to install the driver.
PAGE 3
Cogent systems RF-READER USER MANUAL （DRIVERINSTALL_4）五、驱动安装完成，选择“完成”，如下图， When the installation is completed, choose “done”. （DRIVERINSTALL_5）六、确认驱动安装，在桌面“我的电脑”右键选择“管理”，打开“计算机管理”，选择“设备管理器”，看是否驱动已经正确安装，如下图，为驱动已经安装正确： Confirm if the driver has been installed well.
PAGE 4
Cogent systems RF-READER USER MANUAL “manage”. After open the “computer management”, select “device controller” to check if the driver has been installed well. Look at the picture below, it suggests that the driver has been installed well. z 使用方法： Operation manual: 一、打开 Demo 程序“CLR2007.exe”，如下图： Open the Demo program “CLR2007.
PAGE 5
Cogent systems RF-READER USER MANUAL （DEMO）二、将卡移至读卡区，选择“Read”提示“OK”，读卡成功，如下图： Put the card upon the reading area. Then choose “read”, while massage box suggests that it is well done. The reading procedure is completed. (READ）二、将卡移至读卡区，选择“write”提示“OK”，写卡成功，如下图： Put the card upon the reading area. Then choose “write”, while massage box suggests that it is well done. The writing procedure is completed.
PAGE 6
Cogent systems RF-READER USER MANUAL (WRITE) -6-
PAGE 7
FCC INFORMATION This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.