Instructions / Assembly

The purpose of the installation instructions is to
give information on how to best install new entry
systems. CAUTION: Entry systems are HEAVY!
Always have two people to lift and install. (Use
proper lifting techniques and follow proper
workplace safety practices).
ENTRY DOOR
Installation Instructions
DOUBLE DOOR INSTALLATION:
For Double door installation follow steps 1-3 and 5-10.
When shimming double door unit be aware of the reveal on the
top as well as along the astragal.
It may be necessary to predrill and shim the head as well to
create proper 1/8” reveal.
DOUBLE DOOR INSTALLATION
SIDELITE DOOR INSTALLATION:
For sidelite unit the predrilling required will be on the face
of each sidelite jamb.
Location of predrill should be at the same level as the hinges.
Follow steps 1-3 of installation instructions.
Shim in area of predrill to level on each side of jamb.
Once level, secure each side with 3” screws.
SIDELITE DOOR INSTALLATION
COMPLETION
Once door unit is installed it is important to make sure
any sources of moisture penetration are sealed.
Exterior:
-Completely caulk around the brickmould or moulding of unit to
seal out the weather.
-It is also important to caulk around the bottom of the unit, lling
any gaps.
-Any predrilled holes in face jamb will need to be lled with
wood putty.
Interior:
Before installing interior trim around the unit it is important
to ll any of the gaps between xed wall and back of jambs.
-It is recommended to use a Polyurethane low expansion
foam (window & door insulating sealant).
-Also put a bead of caulk at edge of sill to help seal out the
weather.
-Apply interior trim and ll any holes with wood putty.
0617
Storm Doors: Our doors are energy ecient and storm door
protection is not necessary. If installing a storm door, keep in
mind that it should be ventilated to help reduce the amount of
heat build-up. Full-view, non-ventilated storm doors in areas
where no overhang and constant sun exposure is present will
most likely lead to accelerated issues due to the extreme heat
(UV deterioration, color fading, warping, caulk/sealant oozing).
5 6
Primed wood jambs must be painted within 30 days of receipt
of order to retain warranty.