CODEPENDENT Power 4 Elite Remote Vehicle Control System PC 7600" Owner's Manual :emotes Car Start, Security and Convenience System IMPORTANT NOTE: The operation of the Power Elite as described in this manual is applicable to most vehicles. However, due to the engine yipe and configuration of some vehicles (i.e. diesel engines), some functions AND/OR SAFETY PRECAUTIONS may not apply. Please see your 100372-9 installing dealer for moral information.
Table of Contents Features and Benefits of the Power Elite PC Using Your Remote Transmitter cee cvccnicnnccarnsacacarenn 4 Arming the Security System Fr-arm Mode Disarming the Security System Attempted Intrusion Identification Disabling the IT-s™ Interior Theft Sensor coco vvciiiciiens 5 Two-Stage Door Unlock Activating the Trunk Release Feature Turning on the Vehicle Headlights Windows up/AUX 3 Windows downward 4 Using the Car Finder Feature Personal Protection Alarm (Panic) Remote Start / Stop Feature U
Features and Benefits of the Power Elite PC 7600™ 3 8 Two Easy-to-Use Weather-Resistant Remote Controls The remote controls included with the Power Elite PC 7600™ utilize durable, moisture resistant cases and sealed rubber buttons for ref ability and long life. Rolling code technology prevents the transmitter signals from being duplicated. The button functions are clearly labeled to make the Power Elite PC 7600™ simple to operate.
Using Your Remote Transmitter Fund Te mE ie Sen Ameslan Look Duse Dns be HEAD Boil Proms Tor Core Inner Grain Bess i Hed fe Bros TWEE To Toni Sane Alas Loe Lined Protestantisms Chin Tank Pro sand Hal for Emote Shari Bean Brad and hog Robin Haas DLE ol an wr hinge Rear Boarder Ripen ANE hen reins ALLAH wilt 2 tennis Brags fo nmr Ants reveler ld Experience IEEE TY Fromm TIDE Wo omen Hadar tipsiness Arming the Security System To ann the system, git the vehicle, dose all doors, than mess” the ARM button.
Using Your Remote Transmitter (cont.} 5 Disabling the IT-s Interior Theft Sensor It may be necessary at times to disable the IT-s Interior Theft Sensor, especially when parking in areas (like parking garages) where extreme vibration may cause false alarms. Press the ARM button and then press the FIND/PANIC button within two seconds of pressing ARM to disable the interior theft sensor. The siren will chirp three times to indicate that the sensor is disabled.
8 Using Your Remote Transmitter (cont) Using Valet Mode . If the Passive Arming feature is enabled on your system, Valet mode temporarily prevents the alarm system from arming automatically. This is useful when fusing or servicing your vehicle, Yo enter Valet Mode: With the vehicle ignition on, press the ARM bunion. The red dashboard warning light (status indicator} will turn on for one second, then turn off. This indicates that the system is in Valet mode.
Using Your Remote Starter (cont'd) 7 Remote Start Safely Features For safety and security reasons, the Power Elite PC 7600™ will shut off the vehicle during remote start if any of the following occur: « The vehicle hood is opened » The brake Is pressed before the vehicle ignition is turned on with the key + The engine reaches 3 times its normal idle” » The alarm is triggered As a safety precaution, the vehicle will shut off if left unattended for 15 or 24 minutes, depending on the time preset by your instal
Automatic Convenience Options The Power Elite™ performs a variety of automatic functions to enhance security and comfort. Some of these features are programmable at the time of installation. Please see your installer for further details. ruminated Entry When the alarm system is disarmed, the vehicle courtesy lights will turn on for 1 minute, or until the vehicle is started or the system is re-armed.
System Maintenance 9 Changing the Remote Control Battery The two 3-v lithium batteries (CR2018) supplied in your remote control should last approximately one year, depending on usage. When the battery begins to weaken, you will notice a decrease in range, or the distance from your vehicle that your remote transmitter wilt operate, Follow the instructions below to change the remote transmitter battery. 1. Ingert the edge of a coin into the slot at the top of the remote control.
System Maintenance (cont.) Deleting Lost or Stolen Remote Controls from Your System if one of your remote controls is lost or stolen, follow these instructions IMMEDIATELY to remove the control code from your system. 1, Have all remaining remote controls available. 2. Enter the control programming mode by following steps Adding Remote Controls to Your System (page 8).
System Maintenance (cont.) 1" If your remote control is lost or fails to function, use this procedure to disarm the Power Elite PC 7600™ and start your vehicle, 1. Use the keys to enter the vehicle, The alarm will sound once the door is opened. 2. Insert the key into the ignition and turn to the ON position. 3. Locate and press the emergency override button. The alarm will turn off and then you will be able to start your vehicle.
CODE-ALARM, INC. LIMITED LIFETIME WARRANTY A CODE-ALARM, INC. {"CODE"} vehicle security system sold to a retail consumer purchaser by an authorized dealer of CODE and installed by an authorized dealer of CODE is warrants by CODE to the original retail consumer purchaser to be free from defects in workmanship and materials for the lifetime of the vehicle in which the security system was originally Installed.
EE CODE-ALARM, INC. Theft Protection Plan The Theft Protection Program is designed to provide the retail purchaser of a security system provided by CODE-ALARM, INC.
Notes: FCC COMPLIANCE This device complies with Part 15 of the FCC rules and with R88-210 of Industry Canada, Operation is subject io the following two conditions! 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including any interference that may cause undesired operation. ‘Warning! Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority Io operate the equipment.