User's Manual

User Manual

Remote Control

WASPcam 9820WR

NOTE**: Before pairing the remote to the camera, format the MicroSD card in the camera.

How To Pair the Remote:

1. When the camera is in standby mode, press the menu button twice to enter

system settings.

2. Press the left/right arrow buttons to scroll through the menu, choose remote

control to enter the remote menu. Then select Remote Match.

3. A message will appear on the LCD Screen “Wait Remote Match”, the camera is

now in pairing mode.

4. At the same time, press both buttons on the remote controller to start

pairing. Pairing is successful when the LCD screen shows “Remote Match

OK”

1 - Indicator light

2 – Photo Button - press to take photos,

Press the Inquiry/Record Button (3) and the Photo

button (2) simultaneously to enter Pairing mode

3 – Inquiry/Record Button – press to start/stop

recording, press and hold for 3 seconds to check

the present status of the camera (see below)

Remote Control Indicator Light Status

Status/LED Red LED Light Blue LED Light

Standby

1 time/sec frequently

Flickers about 5sec

Off

Recording Off Light on 3 seconds, then off

Status Inquiry

Power off Light on 3 secs, then off Off

Pairing Long light Long light

Success Light on 3 secs, then off Light on 3 secs, then off

Pairing Mode

Failure Off Off

PAGE 1
User Manual Remote Control WASPcam 9820WR NOTE**: Before pairing the remote to the camera, format the MicroSD card in the camera. How To Pair the Remote: 1. When the camera is in standby mode, press the menu button twice to enter system settings. 2. Press the left/right arrow buttons to scroll through the menu, choose remote control to enter the remote menu. Then select Remote Match. 3. A message will appear on the LCD Screen “Wait Remote Match”, the camera is now in pairing mode. 4.
PAGE 2
Start recording Stop recording Photo 2 times/sec frequent Flickers about 5sec 1 time/sec frequent Flickers about 5sec Off Off Off Flashes once each time you take a photo FCC Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
PAGE 3
IC Statement This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interfe The term “IC: “ before the certification/registration number only signifies that the Industry Canada technical specifications were met. This product meets the applicable Industry Canada technical specifications.