Troubleshooting guide

ManualsBrandsCoast Spas ManualsCD-playersBuoyant Operating Spa System





 

 



Location of Your New Spa 

Electrical Requirements 

 

 

 

 

 

 

 



Northwind™ Series 

Coast Luxury Series, North American & International 

Coast 3-pump Luxury & Platinum Series, Nth America 

Coast 3-pump Luxury & Platinum Series, International 

 

 

Summary of content (23 pages)

PAGE 1
TABLE OF CONTENTS: Important Safety Instructions .................................................. Page 2 Cautions ........................................................................................... Page 3 Setup and Delivery Guidelines Location of Your New Spa .................................................... Page 3 Electrical Requirements ........................................................ Page 3 Start-Up Instructions ...................................................................
PAGE 2
IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY 1) DANGER: Risk of Injury. The suction ﬁttings in this hot tub are sized to match the speciﬁc water ﬂow created by the pump. Should the need arise to replace the suction ﬁttings or the pump, be sure that the ﬂow rates are compatible. Never operate the hot tub if the suction ﬁttings are broken or missing. Never replace a suction ﬁtting with one rated less than the ﬂow rate marked on the original suction ﬁtting.
PAGE 3
drains or other similar hardware within 5 feet (1.5m) of the hot tub shall be bonded to the equipment grounding buss with copper conductors not smaller than No. 6 AWG. e) SAVE THESE INSTRUCTIONS. HYPERTHERMIA Prolonged immersion in hot water may induce hyperthermia. A description of the causes, symptoms, and eﬀects of hyperthermia are as follows: Hyperthermia occurs when the internal temperature of the body reaches a level several degrees above the normal body temperature of 98.6°F (37°C).
PAGE 4
Should your new spa need to go through a gate, the opening should be a minimum of 48 inches and up to 8.5’ overhead clearance depending on the size of the unit. colder weather. • The Cascade spa has a pressurized top load ﬁlter. Loosen bleed screw on ﬁlter lid before removing lock ring. • When draining your Cascade spa please ensure you have drained all water using the sight glass as your guide. START-UP INSTRUCTIONS FILLING YOUR COAST SPA • Your new spa has left the factory cleaned and polished.
PAGE 5
Diagram 03 TYPICAL INSTALLATION - Pump Bleeder (front view) CRYSTAL CLEAR TUBE OZONATOR PUMP PUMP PACK CONTROL LED POWER MODULE VALVES CLOSED OR RUN PUMP WITH NO WATER CIRCULATING IN SPA. THIS COULD DAMAGE PUMPS AND PUMP SEALS. • Refer to page 11 or 13 for setting ﬁlter cycle and programming. FILTER MAINTENANCE Filtration starts as soon as ﬂow is steady through the ﬁlter. As the ﬁlter cartridge removes the dirt from the spa water, the accumulated dirt causes ﬂow resistance.
PAGE 6
• Place clean Cartridge in ﬁlter canister. DRAINING & WINTERIZING YOUR SPA • Replace dome lid and re-tighten retaining ring (ﬁnger tight only). DRAINING YOUR COAST SPA • NOTE: MAKE SURE THE O-RING IS ON THE AIR RELIEF VALVE, AND IS FINGER TIGHT WHEN READY TO START PUMP. This O-ring should periodically be lubricated with a silicone lubricant. After a period of 3-4 months, detergent residues from bathing suits and soap ﬁlm will build up in your spa water.
PAGE 7
to and from the jet pumps. Be careful not to lose the o-rings between the unions and pump housing. • Leave drain valve in the open position and safety cap off. • To completely drain the plumbing lines, a wet/dry shop vac can be used to draw out any remaining water. Place the vac hose over the jet ﬁttings in the spa as well as the plumbing lines in the equipment area. • Remove the ﬁlter cartridge and store in a warm, dry area. • Clean the spa shell and place spa cover on spa.
PAGE 8
THE B.O.S.S. HANDHELD REMOTE FEATURES THE FOLLOWING: • Multifunction device keys On/Off • Spa status monitoring from inside your home T V ( LC D M o n i t o r ) • Data transmission up to 15 feet (must align remote in front of spa receiver) Vo l u m e U p • Data reception up to 150 feet (distance may vary depending on obstacles such as walls, etc.
PAGE 9
- Volume Down button decreases volume of the Sony® Radio/CD player. - Play button starts playing DVD. - Stop button stops playing DVD. - Forward button skips forward to next chapter. - Rewind button skips backwards to previous chapter. - In order to set the audio for DVD/CABLE, turn on the Radio/CD player by pressing ON/OFF button on ﬂoating remote control. Press the button again to switch to AUX (auxiliary input).
PAGE 10
WATER QUALITY MAINTENANCE Maintaining the quality of the water within speciﬁed limits will serve to enhance your enjoyment and prolong the life of the hot tub’s equipment. It is a fairly simple task, but it requires regular attention because the water chemistry involved is a balance of several factors. There is no simple formula, and there is no avoiding it.
PAGE 11
CONTROL PANELS — NORTHWIND™ SERIES 11
PAGE 12
CONTROL PANELS — NORTHWIND™ SERIES (cont’d)
PAGE 13
CONTROL PANELS — NORTHWIND™ SERIES (cont’d) 13
PAGE 14
CONTROL PANELS — NORTHWIND™ SERIES (cont’d)
PAGE 15
CONTROL PANELS — COAST LUXURY SERIES, NORTH AMERICAN AND INTERNATIONAL MODELS ��
PAGE 16
CONTROL PANELS — COAST SPAS THREE-PUMP LUXURY AND PLATINUM SERIES, NORTH AMERICAN MODELS ��
PAGE 17
CONTROL PANELS — COAST SPAS THREE-PUMP LUXURY AND PLATINUM SERIES, INTERNATIONAL MODELS ��
PAGE 18
CONTROL PANELS — COAST SPAS THREE-PUMP LUXURY AND PLATINUM SERIES, INTERNATIONAL MODELS (cont’d) ��
PAGE 19
Electrical Wiring - Diagram 02 (North American customers only) Correct wiring of the electrical service box, GFCI box and pack terminal block is essential. Note: International customers should see their local authorized Coast Spas Dealer for Electrical Wiring Requirements. • Carry out a visual inspection to check for signs of miswiring. • Refer to supplied wiring diagrams. Call an electrician if necessary.
PAGE 20
GLOSSARY OF TERMS AIR CONTROL: Mounted generally on the lip of the spa, it induces warm air from the equipment enclosure into the jet stream through venturi action. JETS: -LAMINAR FLOW JET: A thin stream of water that arcs from the spa lip. May be backlit by Fiber Optic or LED. AIR RELIEF VALVE: Located on top of dome ﬁlter lid. Used to release air on a pressure ﬁlter (Cascade model only). -MASTER MASSAGE JET: A large-aperture jet with multiple nozzles to massage many muscle groups simultaneously.
PAGE 21
TROUBLESHOOTING GUIDE NO HEAT OR HEAT TOO LOW Probable Cause Recommended action Breaker at house OFF. Reset breaker at house. Breaker can appear to be on and one pole can be oﬀ. Turn breaker OFF then ON twice. Inadequate water ﬂow due to dirty ﬁlter. Clean ﬁlter cartridge(s). Pump not primed. Refer to the section of this manual on pump priming. O-ring may be missing or damaged on air bleeds. Improper line voltage. Have a licensed electrician check the line voltage.
PAGE 22
FLOATING REMOTE DOESN’T WORK Probable Cause Recommended action Low battery power Replace with new batteries. Programming of remote is incorrect Refer to remote control user’s instructions included with your spa. LCD Monitor doesn’t respond to ﬂoating remote control or B.O.S.S. • Reprogram the ﬂoating remote control. Follow instructions on how to program ﬂoating remote control or B.O.S.S. No sound • Increase volume on your stereo with either ﬂoating remote control or manually.
PAGE 23
Notes 23 B.O.S.S. Problem If B.O.S.S. loses communication: If B.O.S.S. remote does not respond: There’s no sound when watching Cable/TV • With Monitor’s original remote control, press Volume UP button until you see the volume bar ﬁlled up to maximum. • Repeat with DVD remote control. • Turn ON the Modulator Switch found on the right side of the DVD Player and set the Radio to 89.1 FM. • Check the Modulator Fuse 5A (#4 in the fuse box).