VER1120087520 DESIGN MINI SYSTEM DMS 7520 USER MANUAL
General Imprint All rights reserved. Any reproduction without consent of cmx® is prohibited. cmx® reserves the right to modifications of the device.
General CONTEXTS 1. GENERAL ...................................................................................... - 1 1.1. Safety precautions ................................................................. - 1 1.2. Disposal of Waste Electronic Equipment .............................. - 2 1.3. Battery Disposal .................................................................... - 2 1.4. Copyright ............................................................................... - 2 1.5. Hearing Protection .
General 9.2. USB 2.0 ............................................................................... - 18 9.3. SD and MMC memory card reader ..................................... - 19 10.FURTHER OPERATION................................................................... - 20 11.TROUBLESHOOTING ..................................................................... - 21 12.WARRANTY ................................................................................. - 23 12.1. Warranty Procedure ................
General 1. General 1.1. Safety precautions Only connect to mains power supply (230 Volt/50 Hz). Do not place containers filled with water on top of the device. Do not place the device in close proximity of water (e.g. sink, wash basin, etc.). The device can fall into the water and cause a short circuit. The device consumes some power during standby operation. For zero power consumption disconnect from mains power supply.
General 1.2. Disposal of Waste Electronic Equipment Your product is manufactured from high quality raw materials and should be recycled. Ask your municipality for collecting points for waste electronic equipment. Do not dispose of old appliances with the household waste. The symbol on the product, the instructions for use or the packing will advert about the methods for disposal. 1.3. Battery Disposal The law requires returning exhausted batteries to public collection points or the dealer.
General Only turn the volume to a level where you can still hear ambient noise. 1.6. Cleaning and Maintenance Cleaning the Casing Clean the casing with a dry cloth. Before cleaning disconnect from mains power supply. Do not clean with liquid cleaning agents or a wet cloth; this can cause a short circuit. Cleaning CDs Clean CDs with a soft cloth from the center to the edge. Do not use solvents or abrasive cleaning agents. Do not use pointed or sharp utensils for cleaning; this will damage the CD.
Features 2. Features This HiFi system – DMS 7520 can play all Audio CDs and MP3 CDs. Music playback is also possible via USB port and SD card reader. In addition you can play audio cassettes on this unit.
Location of controls 3. Location of controls 3.1.
Location of controls RADIO, USB, SD 12 LCD Display 13 Cassette deck Cassette compartment 14 OPEN Cassette controls 15 Phones Earphones/headphones jack 16 CD drive Open CD drive 17 USB Port for MP3 player / USB stick 18 SD/MMC SD or MMC card slot 3.2.
Location of controls 3.3.
Location of controls 13 MUTE Mute the sound 14 VOL- Decrease volume 15 VOL+ Increase volume 16 Battery compartment Battery compartment cover -8-
Preparation 4. Preparation 4.1. Connections Follow these steps to connect the system: Step 1 L RL RL R Step 2 1. Clamp the white wires to the red terminals at the rear. Clamp the black wires to the black terminals; see drawing: 2. Connect the mains power cable first to the system and then to a wall outlet. The system is in standby mode and the status indicator lights up red.
Preparation Only use a power adapter with input 230 Volt/50 HZ and output 12V 2.25A. Further information regarding connections see in chapter 9. 4.2. Insert battery The battery compartment is at the top of the remote control 1. Insert two AA batteries (1.5V LR6) observing the polarity (+ and -) as marked inside the battery compartment. Notes: Batteries not included - 2 pieces AA (1,5V LR6) for remote control necessary! The lifetime of the battery is approximately 6 months with normal use.
Preparation 3. Press the / FM ST. button to toggle between 12-hour and 24-hour format. 4. Press PROGRAM / PLAY-MODE. The hour display flashes. 5. Press the / FM ST. or /BAND button to set the hours. 6. Press PROGRAM / PLAY-MODE. The minute display flashes. 7. Press PROGRAM / PLAY-MODE. 8. The current time is now set. The settings are deleted if you disconnect the system from mains power supply and in case of power failure.
CD-Player 5. CD-Player 5.1. Insert CD / MP3-CD 1. Press the button on top of the unit to open the CD drive. 2. Insert a CD with the label up and carefully press it down onto the ball bearing spindel. 3. Close the CD drive manually. 5.2. CD / MP3-CD playback This system can play CDs / MP3 CDs in different playback modes. 1. Press the PROGRAM/PLAY-MODE button on the remote control to select the desired mode.
CD-Player 5.3. Program CD/ MP3 tracks You can program your own playlist with up to 20 tracks. 1. During CD / MP3-CD playback press the STOP button before programming. 2. Press the PROGRAM / PLAY-MODE button until 00 P— 01 is displayed. 3. Press / FM ST. or /BAND on the remote control until the desired track is displayed. 4. Press the PROGRAM / PLAY-MODE button to confirm. 5. Repeat step 2 and 3 to program further tracks. Your programming was successful if „PROG“ is displayed.
Cassette deck 6. Cassette deck There is a cover below the cassette deck. 1. Flip the „OPEN“ button forward to open the cover. 6.1. Insert cassette 1. Bellow the cassette deck you find the „OPEN“ button for cassette playback. 2. Press the STOP/OPEN button to open the cassette compartment. 3. Insert the cassette with the recorded side to the front. 6.2. Cassette playback 1. Insert a cassette as described under point 6.1. 2. Press the PLAY button to start cassette playback.
Cassette deck Do not disconnect the device when „USB“ mode is selected. The same is valid for other devices. Connect or insert your device. 1. Connect or insert your music source. 2. Insert a cassette into the cassette compartment. 3. Simultaneously press the RECORD and PLAY buttons to record to cassette. The audio cassette has two sides. Please insert the cassette the correct way. The cassette must be rewound. In recording mode playback of other sources is not possible. 6.4.
Radio 7. Radio 7.1. Listen to radio 1. Press the FUNCTION button until „RADIO“ is displayed. 2. Select AM or FM stereo. 3. Turn the tuning knob to tune into your favorite radio station. For best reception point the antenna in a different direction or choose a different location.
Sound scenarios 8. Sound scenarios 8.1. Effect 1. Press MENU. 2. Repeatedly press the /FM ST or /BAND button to select the desired sound scenario. 3. Press the ENTER / X|| button to confirm. Select between the following sound scenarios: Flat Pop Rock Jazz Classic In FLAT mode the equalizer is deactivated.
External Components 9. External Components 9.1. Connect Earphones 1. Connect your earphones or headphones. The speakers are muted if earphones are connected. To avoid hearing problems do not use earphones or headphones for an extended period of time. Increased sound pressure from earphones or headphones can cause hearing loss. See chapter 10 for further settings. 9.2. USB 2.0 Extend your system by connecting your MP3 player or USB stick. Do not disconnect the device when “USB” mode is selected. 1.
External Components 9.3. SD and MMC memory card reader Extend your system by inserting an SD or MMC memory card in the card reader. Do not disconnect the device when “SD” mode is selected. 1. Insert the SD or MMC card in the card reader. 2. Press the FUNCTION button until “SD” is displayed. 3. Press the PLAY button to start playback. To avoid damage only disconnect the device after pressing the STOP button and selecting a different mode with the FUNCTION button. See chapter 10 for further settings.
Further operation 10. Further operation This operation you have for CD playback and for external components (SD / MMC / USB). Prozedur Bedienung Stop playback Press STOP. Pause Press the PLAY/PAUSE button. Zum Fortfahren drücken Sie erneuert die Taste. Skip mode Press /FM ST or /BAND during playback or pause modes. Skip to next folder Press FOLDER-UP.
Troubleshooting 11. Troubleshooting Contact the service hotline or use the contact form on the homepage in case of problems with the system that are not dealt with here. Malfunction Solution “No disc” Insert a CD. Insert a finalized CD-RW or CD-R. Insert the CD with the label up. Try another CD or clean the CD. Increase the distance to TV set or Bad reception DVD player. Point the antenna in a different direction.
Troubleshooting connected. Remote control Increase the volume. Disconnect the earphones. Deactivate MUTE mode. Decrease the distance to the system. does not work. Exchange the battery. Point the remote control towards the system’s IR sensor. No CD playback. Check your CD for damages or scratches. USB stick / SD memory card does Insert the CD with the label up. Use a different USB stick or SD card to check the function.
Warranty 12. Warranty This system comes with a 24-month warranty from the date of purchase. Please keep your purchase documents! In case of manufacturing or material defects the warranty consists of rectification of defects or exchange. The warranty does not include damages or malfunctions due to improper use wear and tear repairs by third parties The warranty does not include display damage firmware update accidental damage. Repair does not extend the warranty period. 12.1.
Warranty Service hotline o Austria: +43 0720 502671 – please dial with the zero! o Germany: +49 (0)180 166 66 264 621 o Switzerland: +41 (0) 848 00 3322 Contact form – www.cmx-electronics.com 12.2. Warranty has expired Please contact us by phone or contact form in case your warranty has expired. We will help you! Please inform us about the following: Unit type Purchase date Malfunction 12.3.
Warranty Attach filled-out warranty card Error description Example for error description Wrong Correct Unit is defective Unit does not respond Unit malfunctions Unit cannot be switched on Sender information: Name, address, ZIP code, city and phone number and e-mail address - 25 -
In the box 13. In the box Please contact your dealer directly in case one of the accessories is missing or damaged.
Technical specifications 14. Technical specifications CD-Player Formats Audio CD / Audio CD-R / Audio CDRW MP3 CD / MP3 CD-R / MP3 CDRW Frequency range 100 Hz ~ 16 kHz S/N ratio 50 dB Radio Frequency bands AM / FM Stereo frequencies AM 522 – 1656 kHz FM 87,5 – 109 MHz Connectors inputs USB 2.0 outputs 3,5 mm headphones speakers (left / right) Card reader SD cards MMC cards Speakers Power output Max.
Technical specifications General Power consumption 12 Watts Mains power AC 230 V ~ 50 Hz dimensions 203 x 222 x 140 mm - 28 -
Technical specifications www.cmx-electronics.