Instructions / Assembly

CLOSURE VENT CV3
Closure Vent is die cut to perfectly fit the Classic Rib panel
profile and does not require a special ridge cap.
The adhesive is designed to make application easier, keeping
the vent in place until the ridge cap is fastened.
INSTALLATION INSTRUCTIONS
Simply install your roof panel with a two inch opening
between the top of the panel and the peak of the roof then
follow these simple instructions:
1. Peel paper from adhesive on vent
2. Place Closure Vent on the panel with screened piece
toward the front – position so that fasteners will go
through the web of the closure when the ridge cap is
installed
3. Install ridge cap