Manual

S 80
PROFESSIONAL MICROPHONE SYSTEMS
A low profile through table microphone base designed specifically for Clockaudio through table microphones
(C 003E-RF, C 004E-RF, C 011E-RF and C 012E-RF)
www.clockaudio.com
• Designed for remote switching.
• Low profile table mounted microphone base.
• Designed to be used with C 003E-RF,
C 004E-RF, C 011E-RF and C 012E-RF.
• Uses the shock mounts from the microphone
to eliminate surface bound noise.
• Fitted with latching or momentary PTT switch.
• Bi-colour common anode LED to confirm
status
• Terminated with RJ 45 connector and supplied
with RJ 45 coupler which allows connection via
RJ 12 or RJ 45 plug back to dsp.
Cable colour
Function
RJ 45 Pin number
Red
Red LED cathode
2
Blue
COM switch
3
Brown
LED anode
4
Yellow
PTT switch
5
Green
Green LED cathode
6
Pre drill 50mm (2”) hole in table
Remove nut and 1 shock mount from
the microphone and place into S 80
top.
With the S 80 top and mic in desired
position use the 2 self tapping screws
supplied to fit the S 80 base plate.
Ensure wires run free through hole in
base plate.
Fit remaining shock mount and
hand tighten nut to secure mic and
S 80 top plate.