Clockaudio ARM-C Control Box Instructions www.clockaudio.com email: info@clockaudio.co.
Product Guarantee Thank you for purchasing a Clockaudio product. We are confident that this product will give you many years of trouble free operation and is backed up with a 2 year guarantee. Important: Guided Tour systems, Mixers and RF products must have the guarantee activated by completing the registration details on Clockaudio web site. Look for the warranty tab under the Technical Library. Clockaudio will retain the details on their database for future reference.
ARM Control Box Overview Link / DSP (2 x RJ12) control ports allow DSP connection and Link / daisy chain expansion to other control boxes. A single command from a DSP will simultaneously activate all connected ARM motorised microphones. Logic input connections to the Link / DSP control ports pin 2 live and 1 Gnd. A positive (+2.
Connections 1. Install the ARM motorised microphone as per separate instructions given with the product. 2. Ensure that the Control box power supply is NOT switched on until all wiring and connections have been completed. 3. Connect the ARM motorised microphone plug/s to any of the M1 – M4 motor outlet ports on the Control box. It does not matter which port is used as they are connected in parallel. 4. Connect the DSP logic signal output terminals to the DSP input socket on the Controller box.
CONNECTING 4 X ARMC CONTROL BOXES USING SINGLE AC ADAPTOR Negative Ensure correct polarity Positive + DC Input from AC adaptor: Connecting 4 ARM-C using single high power AC adaptor (ARM-PSU 4). Connection / termination blocks (not supplied) will be required.
If the RJ12 cables need to be lengthened readymade / off the shelf extension cables are freely available at your high street electrical retail outlet. If cables are to be handmade then connections are made to pins 2 (Live) & 1 (Ground) shown below all other pins are not used. Troubleshooting Guide Microphone does not move up or down Microphone is picking up noise as it is being raised / lowered. Check that the DSP control signal is present logic +2.5 to 12 Volts is required.